5
Locations subject to vibrations, such as on vehicles, marine vessels, or above product lines (This
•
product is not designed for on-vehicle use.)
Locations subject to condensation as the result of severe changes in temperature
•
Mounting method for this product
This product is designed to be used as a pendant mount camera. If the product is mounted on a
desktop or at a slant, it may not work correctly and its lifetime may be shortened.
Procure anchor bolts separately.
An anchor bolt for mounting the bracket on a ceiling is not supplied with the ceiling mount bracket.
Prepare them according to the material and strength of the area where the product is to be
installed.
Anchor bolt: M10, recommended
•
Minimum pull-out strength: Make sure that more than 5 times of the total weight including the
•
camera body can be supported.
Tightening the screws and bolts
The screws and bolts must be tightened with an appropriate tightening torque according to the
•
material and strength of the installation area.
Do not use an impact driver. Use of an impact driver may damage the screws or cause tightening
•
excessively.
When a screw is tightened, make the screw at a right angle to the surface. After tightening the
•
screws or bolts, perform checks to ensure that the tightening is sufficient enough so that there is
no movement or looseness.
Make sure to remove this product if it will no longer be used.
