![background image](http://html.mh-extra.com/html/panasonic/wv-cw7cn/wv-cw7cn_operating-instructions-manual_277897003.webp)
3
ENGLISH
Step 3
Replace the dome cover
q
Attach the waterproof rubber provided with
the new dome cover to the enclosure. Make
sure that the waterproof rubber is attached
without distortion or deformation. Do not
use the waterproof rubber removed from
the enclosure. Use the new waterproof rub-
ber provided with the new dome cover.
w
Remove the protection film covering outside
the new dome cover.
Keep the removed protection film until using
it upon the installation.
(Handle the new dome cover with care not
to scratch inside and outside.)
e
Fit the new dome cover and the dome
cover holding plate together while aligning
the holes on them to the 2 protrusions
inside the enclosure, and then fix them
using the 2 dome cover fixing screws (with-
out washers).
(Recommended tightening torque:
0.78 N·m {0.58 lbf·ft})
r
Attach the protection film removed in
step 3 -
w
back to the outside the dome
cover.
t
When fixing the third dome cover fixing
screw (with washer), fix the installation auxil-
iary wire together.
When fixing with the screw, make sure that
the flat face of the fixing terminal is the sur-
face side of the dome cover holding plate.
Make also sure that the fixing terminal is not
on the projection of the dome cover holding
plate. (Refer to the diagram on the next
page.)
(Recommended tightening torque:
0.78 N·m {0.58 lbf·ft})
Step 4
Fit the enclosure back to the camera body
Fix the enclosure onto the camera body using
the 4 enclosure fixing screws.
The recommended tightening torque for the
enclosure fixing screws is 0.78 N·m {0.58 lbf·ft}.
⇒
Refer to the Installation Guide of the camera
for the subsequent procedures including the
installation of the camera body.
IMPORTANT:
• Defocus may be caused by the reinstalled
enclosure. After installing the enclosure,
activate the auto focus function from the
setup menu.
• Remove the protection film covering the
outside of the dome cover after completing
the installation.
• Refer to “Precautions” (next page) and
clean the dome cover.
Attach the “ClearSight coating label” with WV-
CW7CN to the surface of the enclosure.