Panasonic WV-CW384E, Руководство по эксплуатации

Страница: 22 / 218

22
■
Basic operation
The following are descriptions of how to configure each setup item using the operation buttons (refer to page 8) on the cam-
era. Setup using an optional system controller is also available.
Note:
• The illustrations below are the examples to be displayed on a video monitor.
1. Hold down the [SET] button for around 2 seconds.
→
The top page will be displayed.
2. Move the cursor onto "END" by press the [UP] or [DOWN] but-
ton.
MODEL WV-CW380 SERIES
CAMERA
O
BACK-FOCUS
O
SPECIAL
O
LANGUAGE O
END SETUP DISABLE
3. Press the [SET] button after moving the cursor onto "SETUP" by
pressing the [RIGHT] button.
→
The "DISABLE" indication will change into "ENABLE" and
the settings will become editable.
MODEL WV-CW380 SERIES
CAMERA
O
BACK-FOCUS
O
SPECIAL
O
LANGUAGE O
END SETUP ENABLE
4. Move the cursor onto the desired setup item and press the
[SET] button.
→
The setup page of the selected setup item will be dis-
played.
5. Configure the settings for each item.
Select setup item: Move the cursor by pressing the [UP] or
[DOWN] button.
Change the parameter: Press the [LEFT] or [RIGHT] button.
Display the detailed settings page of the setup item: Press
the [SET] button when the setup item with the [
O
] mark is
selected.
Go back to the previous page: Move the cursor onto "RET"
and press the [SET] button.
Go back to the top page: Move the cursor onto "TOP" and
press the [SET] button.
**CAMERA SETUP** 1/2
CAMERA ID OFF
O
ALC ALC O
SHUTTER OFF
AGC ON(HIGH)
SENS UP OFF
SYNC INT
WHITE BAL ATW1
O
MOTION DET MODE1
O
DNR HIGH
RESOLUTION HIGH
BW MODE
O
**CAMERA SETUP** 2/2
PRIVACY ZONE OFF
EL-ZOOM OFF
STABILIZER OFF
LED ON
RET TOP END
6. To exit from the SETUP menu and display images from the camera, move the cursor onto "END" and press the [SET] but-
ton.
Notes:
• To prevent erroneous operations, the "DISABLE" indication will always be displayed when the top page is displayed from
the camera. To operate the SETUP menu, switch the "DISABLE" indication to the "ENABLE" indication first.
• The cursor position will be displayed highlighted.