18
Camera system setting [SYSTEM SETUP]
Performs the settings relating to the camera system such as synchronization, alarm input/output terminal and privacy zone. The
following settings can be configured on the “SYSTEM SETUP” screen displayed from the top screen.
Refer to page 5 for how to call up the screen.
10. Synchronization method [SYNC]
Only internal synchronization (INT) can be used.
Multiplexed vertical drive (VD2) synchronization cannot be used.
11. Alarm input/output terminal setting [ALARM IN/OUT]
Configure the settings relating to the alarm input/output terminal as follows.
Configure the alarm input terminal setting
Select the operation of the alarm input terminal. Follow the procedure below.
“SYSTEM SETUP” screen
**SYSTEM SETUP**
SYNC INT
ALARM IN/OUT
PRIVACY ZONE OFF
STABILIZER OFF
EL-ZOOM OFF
UPSIDE-DOWN OFF
LDC I...... 0
- +
RET TOP END
“ALARM IN/OUT” screen
**ALARM IN/OUT**
ALARM IN OFF
ALARM OUT OFF
RET TOP END
Step 1
Move the cursor to "ALARM IN/OUT" and press the [SET] button.
→
The "ALARM IN/OUT" screen appears.
Step 2
Move the cursor to "ALARM IN" and select the alarm input terminal operation from the following.
OFF
(default)
:
No terminal input is accepted.
ALARM:
Activates the alarm action when the terminal input is active for more than 100 ms.
VMD PERMIT:
Activates the VMD function when the terminal input is active. It is necessary to set actions to be taken in the "VMD"
section in advance.
BW:
Automatically activates the black-and-white mode when the terminal input is active.
SCENE2:
Operates the camera with the settings of "SCENE2" when the terminal input is active.
When no terminal input is received, the camera will work with the settings of "SCENE1".
Note:
• The “VMD PERMIT” function is only effective when “VMD” is set to “MOTION DET” or “SCENE CHANGE”.
“SYSTEM SETUP” screen
**SYSTEM SETUP**
SYNC INT
PRIVACY ZONE OFF
STABILIZER OFF
EL-ZOOM OFF
UPSIDE-DOWN OFF
- +
LDC I...... 0
RET TOP END
ALARM IN/OUT
