![background image](http://html1.mh-extra.com/html/panasonic/wv-cp620-g-series/wv-cp620-g-series_installation-manual_3795762020.webp)
20
Important:
• Check whether the cord core is fully inserted into the
power cord plug.
<
Ratings
>
24 V AC
12 V DC
- 2-N
(GND)
+ 1-L
⊕
3
Tighten the screw of the power cord plug.
4
Connect the power cord plug to the power supply
terminal on the rear side of the camera.
Important:
• Make sure that the power cord plug is inserted fully into
the power supply terminal.
Connection of power cord
When connecting the power cord, use connectors that are designed for the power cord, and be care
-
ful not to let the power cord fall off.
In addition, waterproofing work is needed at the joint, e.g., wrapping waterproof tape around the joint.
Cable length and wire gauge
24 V AC
The recommended cable length and wire gauge are shown in the table for reference. The voltage
supplied to the power terminals of the camera should be within 19.5 V AC and 28 V AC.
Power supply
(24 V AC
or 12 V DC)
24V~IN 2-N
1-L
1 2 3
12V IN
-,
VIDEO OUT
WV-CP604E, WV-CP624E
Important:
• Use 24 V AC or 12 V DC power supply that is insulated
from 220 V-240 V AC power.
• The power supply is automatically switchover either 24 V
AC or 12 V DC. No setting is required with this camera.
1
Loosen the screw of the power cord plug (accessory).
2
Connect the power supply of 24 V AC or 12 V DC to the
power cord plug.
Strip the end of the wire by 3 mm to 7 mm, and twist
the stripped part of the wire sufficiently to avoid short
circuit.
Specification of power cord (wire):
AWG #16 - #24,
Single core, twisted
3 mm - 7 mm
Power cord
plug (accessory)