Panasonic WV-CP280 Series, Руководство по эксплуатации

Страница: 10 / 114

10
q
Flange-back adjustment ring
This ring adjusts the back-focal distance
or picture focus.
Important:
• When an object is out of focus
because it is too close to the cam-
era, focus on a darker object with the
aperture open.
w
ALC lens connector
Supplies power and control signals to an
auto iris lens (option).
e
Lens (option)
Important:
• The lens mount should be a CS-
mount (1"-32UN).
• The protrusion at the rear of the lens
should be as shown in the diagram
to prevent damaging the camera.
r
Flange-back lock screw [LOCK]
Loosen this screw with a screwdriver to
adjust the flange-back adjustment ring.
When completing the adjustment, tighten
this screw.
Recommended tightening torque:
0.05 N·m {0.5 k g f·cm}
Important:
• When the screw is tightened stronger
than the recommended tightening
torque, it may strip the thread or
cause focus misalignment.
t
Mount adapter
The camera mounting screw hole is for
mounting the camera onto a mounting
bracket. The camera is originally
designed to be mounted from the bot-
tom, however, a top-mounting type is
also available. To mount from the top,
remove the mount adapter from the bot-
tom of the camera by removing two fixing
screws.
Attach the mount adapter to the top as
shown in the diagram, then mount the
camera on the mounting bracket. Make
sure that two original screws are used
when mounting the mount adapter;
longer type screws may damage inner
components, too shorter type screws
may cause the camera drop.
y
Power cord (WV-CP280 only)
Connect this power cord to an electrical
outlet of 220 V-240 V AC 50 Hz.
u
24 V AC/12 V DC input terminal [AC
24V IN/DC 12V IN] (WV-CP284 only)
This terminal is for connecting the 24 V
AC 50 Hz/12 V DC power supply cord.
i
GND terminal [GND] (WV-CP284 only)
o
Video output connector [VIDEO OUT]
Composite video signals are transmitted.
If this unit is connected to the multiplex
unit, the multiplexed VD2 that is priori-
tized over INT/LL is automatically select-
ed.
!0
Dip switch
Selects ON/OFF for light control mode,
backlight compensation, Adaptive Black
Stretch, simple day/night mode, and
INT/LL for synchronization mode.
INT
ALC
ON
ON
B.S.
ON
BLC D/N
LL
ELC
OFF
OFF
OFF
CS-mount: Less than 8 mm {5/16"}