![background image](http://html.mh-extra.com/html/panasonic/wv-cf250/wv-cf250_operating-instructions-manual_277750019.webp)
-17-
4. Repeat step 3 to mask the desired areas. To
cancel masking, move the cursor to that area
and press
(S).
5. After masking is completed, press
(S) for 2
seconds or longer. The ALC CONT menu
appears.
6. If you want to change the video output level
(picture contrast), move the “I” cursor to
LEVEL and adjust the level.
7. Move the cursor to RET and press
(S) to
return to the CAM SET UP menu. (To return to
the camera picture, move the cursor to END
and press
(S).)
3. Shutter Speed Setting (SHUTTER)
Note:
When ON is selected for SUPER-D on the
ALC CONT menu, this item is not available.
To select electronic shutter speed, select OFF
for SUPER-D in the menu.
You can select an electronic shutter speed of 1/50
(OFF), 1/120, 1/250, 1/500, 1/1 000, 1/2 000, 1/4 000,
or 1/10 000 seconds.
Blinking
Turns to white
Move the cursor to the SHUTTER parameter and
select the electronic shutter speed.
The preset values for SHUTTER (electronic shutter
speed) change by pressing
(L) or
(R) as
follows:
** CAM SET UP **
CAMERA ID OFF
ALC/ELC ALC
SHUTTER ---
AGC ON
SYNC INT
WHITE BAL ATW
END SET UP ENABLE
↵
↵
↵
OFF (1/50)
1/120
1/10000
1/4000
1/2000
1/1000
1/250
1/500
4. Gain Control Setting (AGC ON/OFF)
You can set the gain (brightness level portion of an
image) to automatic level adjustment (ON) or fixed
level (OFF).
Move the cursor to the AGC parameter and select
automatic level adjustment (ON) or fixed level
(OFF).
5. Synchronization Setting (SYNC)
You can select internal sync mode (INT) or line-lock
mode (LL). The VD2 signal (multiplexed vertical
drive signal) with the composite video output signal
from external equipment such as a Matrix Switcher
is also acceptable.
Whenever the VD2 signal is supplied to this cam-
era, the camera automatically switches to the VD2
sync mode.
1. Move the cursor to the SYNC parameter and
select line-lock (LL) or internal (INT).
2. Press (S).
If LL is selected, the SYNC menu appears. (If
INT is selected, the synchronization mode is
automatically set to internal sync pulse, and
the menu is not displayed.)
** CAM SET UP **
CAMERA ID OFF
ALC/ELC ALC
SHUTTER ---
AGC ON
SYNC INT
WHITE BAL ATW
END SET UP ENABLE
↵
↵
↵
** CAM SET UP **
CAMERA ID OFF
ALC/ELC ALC
SHUTTER ---
AGC ON
SYNC INT
WHITE BAL ATW
END SET UP ENABLE
↵
↵
↵
Important Notices:
1. The priority for the sync modes is as follows.
1. Multiplexed Vertical Drive (VD2) (Highest
priority)
2. Line-lock (LL)
3. Internal Sync (INT) (Lowest priority)
2. The line-lock mode has its own menu for line-
lock vertical phase adjustment. If the camera
installation is relocated, check the vertical
phase adjustment again since the AC line
phase may be different.