(1) Use the HDD cable holding clamps attached to the
RAID board to bundle two of the HDD cables each
disconnected in Step 2.
(2) Connect all of the HDD cables and 3 cables to the
RAID board.
7. Put the top cover back and secure it with the screws
removed in Step 1.
5. Mount the RAID board.
(1) Mount the RAID board so that the mounting holes
(
q
to
r
) of the RAID board are aligned with the
mounting holes (
q
to
r
) of the main unit (WJ-
ND300) respectively by referring the illustration.
(2) Secure the RAID board to the main unit with the
screws (6 screws with washer for top of the board,
2 screws for rear of WJ-ND300, and 1 flat-head
screw for side of WJ-ND300) attached to the board.
6. Connect the cables to the RAID board.
The original positions of the HDD cable connectors on
the main board of the WJ-ND300 and the positions of
the RAID board are as shown in the illustration below
(Fig.1).
4
Pass the HDD cable for HDD1
(HDD3) through the pull-ring of
the cable for HDD2 (HDD4).
HDD cable
holding clamp
Flat-head screw
q
w
e
r
t
y
u
i
o
q
q
w
w
e
e
r
r
RAID board of
the WJ-ND300
w
q
q
w
e
e
r
r
