Panasonic (WH-UD12CE5-A-1, Руководство по обслуживанию

Страница: 55 / 158

55
š
An external filter (30 mesh or more, field supplied)
must be installed before the water inlet of the indoor
unit (with “WATER IN” indication).
š
Refer to Diagram 4.1 for pipe connection of
Radiator, Floor Heater, Tank Unit, Solar Pump
Station, 3-way Valve Kit and etc. Fail to connect the
pipes appropriately might cause the unit malfunction.
š
Be sure to use two spanners to tighten the
connection. Further tighten the nuts with torque
wrench in specified torque as stated in the table.
š
If non-brass metallic piping is used for installation,
make sure to insulate the pipes to prevent galvanic
corrosion.
š
Make sure to insulate the water circuit pipes to
prevent reduction of heating capacity.
š
After installation, check the water leakage condition
in connection area during test run.
Nut size (Torque)
Model
Water
SDF12C6E5/UD12CE5**,
SDF14C6E5/UD14CE5**,
SDF16C6E5/UD16CE5**
Rp 1¼” [117.6 N•m]
CAUTION
Do not over tighten, over tightening cause water leakage.
12.3.3.3 Indoor Unit Refrigerant Pipe
Installation
1 Please make fl are after inserting fl are nut
(located at joint portion of tube assembly) onto
the copper pipe. (In case of using long piping)
2 Do not use pipe wrench to open refrigerant
piping. Flare nut may be broken and cause
leakage. Use proper spanner or ring wrench.
3 Connect the piping:
o
Align the center of piping and sufficiently
tighten the flare nut with fingers.
o
Further tighten the flare nut with torque
wrench in specified torque as stated in the
table.
Piping size (Torque)
Model
Gas Liquid
SDF12C6E5/UD12CE5**,
SDF14C6E5/UD14CE5**,
SDF16C6E5/UD16CE5**
ø15.88mm (5/8”)
[65 N•m]
ø9.52mm (3/8”)
[42 N•m]
CAUTION
Do not over tighten, over tightening cause gas leakage.
12.3.3.4 Drain Hose Installation
š
Use inner diameter 15 mm drain hose in the market.
š
This hose must to be installed in a continuously
downward direction and in a frost-free environment.
š
Guides this hose’s outlet to outdoor only.
š
Do not insert this hose into sewage or drain pipe
that may generate ammonia gas, sulfuric gas, etc.
š
If necessary, use hose clamp to further tighten the
hose at drain hose connector to prevent leakage.
š
Water will drip from this hose, therefore the outlet of
this hose must be installed in an area where the
outlet cannot become blocked.