Panasonic VL-PS2410, Руководство по установке

Страница: 9 / 12

3.2.2 Information about the power supply unit
The VL-PS2410 power supply unit has 6 DC OUT connections terminals. (Use the VL-PS2410 so that the combined
output does not exceed 2.5 A. Check the power consumption of each device for more information.)
3.2.3 Mounting on a DIN rail
Attach the power supply unit to the DIN rail so that the bottom hook is positioned at the bottom of the power supply
unit.
1
Hang the top hooks ( A ) of the power supply unit on the top of the DIN rail.
R At this point the power supply unit will be hanging from the DIN rail but will not be secure.
2
Pull the lever ( B ) down, make sure the bottom of the power supply unit is flat against the DIN rail, and then release
to lever.
R The bottom hook ( C ) will slide up, securing the bottom of the power supply unit to the DIN rail.
B
A
C
3.2.4 Attaching directly to a wall
Attach the power supply unit to the wall securely using the 2 mounting screws ( A ).
A
3.2.5 Wire type and maximum wire length
Wiring run Wire diameter Max. length
Power supply unit
«
Connected device
(example: lobby station,
distributor, main monitor,
etc.)
0.65 mm (22 AWG)
approx. 50 m
*1
2 mm (12 AWG)
approx. 100 m
*1
Power supply unit
«
AC power source
1.2 mm (17 AWG)
No requirement
2 mm (12 AWG)
*1 The maximum wiring length differs depending on the connected device. For details, refer to the documentation
included with the device.
Note the following when selecting wiring
R Use 2-conductor (solid copper) wiring with a PE (polyethylene)-insulated PVC jacket.
Mid-capacitance, non-shielded cable is recommended.
9
3. Installation