16
To attach the wires
•
Strip off of the wire cover so that about 9 mm (
3
/
8
″
) of the wire is exposed.
•
While pressing on the button with a pointed object such as a screwdriver, insert
the wire into the terminal connector.
•
To disconnect a wire, press on the button while pulling out.
Introduction and Installation
Note:
•
To open the case again, push the bottom of the front case, then release from the
rear case.
To attach the power cable
•
While pressing on the button hard with a pointed object such as a screwdriver,
insert the power cable into the terminal connector.
•
To disconnect the power cable, press on the button hard while pulling out.
•
To attach an optional power cable, cut off about 12 mm (
1
/
2
″
) of the cable cover
(
), then push in firmly until the end of the cable is securely inserted into the
power connection terminal (
).
Sub Monitor station
Button
Terminal
connector
Button
Terminal
connector
Power cable cross section
Correct
Incorrect
DC terminal
Содержание VL-GM001
Страница 19: ...19 ...
