On screen messages
●
Frequently Asked
Questions
●
FAQs, etc.
85
Message
Meaning / Action
All tuning data will be erased
“Shipping Condition” will erase all tuning data (p. 46).
●
Are you sure ?
Confirm correct operation.
●
Are you sure you want to delete this timer ?
Press OK to delete timer
Press RETURN to return
Confirm correct operation.
●
Bad signal
The signal is weak. Check the aerial is plugged in properly. It may
●
be necessary to have an aerial installer check the signal and aerial
alignment.
Reset channels. (p. 34 and p. 35)
●
Child Lock is active !
Press OK to enter PIN.
The selected channel is locked in Child Lock (p. 45). You must enter the
●
PIN number before the channel will be displayed.
Ethernet cable not connected
Check the connection of the LAN cable. If you use a hub, also check the
●
light on the hub is lit.
The LAN cable might be defective.
●
Faulty dish
The satellite cable might be short-circuited or there might be connection
●
problems of the cable. Check the cable and connection and then turn the
TV Off with the Mains power On / Off switch, and turn it On again.
If the message still persists, it may be necessary to have a dish installer
●
check the dish and cable.
Feature not available
It is not possible to record from COMPONENT, HDMI or PC. Connect the
●
recorder to the TV using a fully wired SCART cable for recording from the
TV tuner.
Confirm Q-Link or VIERA Link settings (p. 66 - 69).
●
Found new software version
∗∗∗
.
Press OK to start update
(may take 40 mins)
or Press EXIT to ignore
and you can update when TV is in standby.
There is a new software available.
●
Gateway does not answer.
Please confirm connection and setting of
router.
A connection failure has occurred and the gateway is not responding.
●
Check the settings and connections of the router.
Turn the TV and the router Off with the Mains power On / Off switch, and
●
turn them On again.
Invalid operation - Please check settings
and connections.
Check the Q-Link or VIERA Link connection and setting (p. 66 - 69).
●
Invalid system time. Please exit !
Cannot get the time information. Check the connection of the RF cable.
●
IP address conflict
Duplicate IP address has been detected. Check the IP address of other
●
equipment such as computers, routers and ensure that there are no
duplicate IP address.
IP address not set
An IP address is required to use interactive content through the internet.
●
Enter an IP address.
On screen messages