T
uning and Editing Channels (D
VB)
42
Set DVB channel manually [Manual Tuning]
Normally use [Auto Setup] or [Update Channel List] to retune DVB channels.
If tuning has not been done completely or for adjusting the direction of the aerial, use this function.
t
All channels found will be added to the Channel List.
DVB-C :
1
Enter the frequency
2
Select [Start scan]
74,00
MHz
4
1
00 %
1
00 %
DVB-C Manual Tuning
Frequency
Auto
Symbol Rate
Service ID
Auto
Stopped
Start scan
Signal Quality
Signal Strength
No.
Channel Name
Type
New
Free TV: 0
Pay TV: 0
Radio: 0
abc
def
jkl
ghi
mno
tuv
pqrs
wxyz
t
Normally set [Symbol Rate] and [Service
ID] to [Auto].
access
select
DVB-T :
1
Adjust frequency for each channel
2
Search
100
[CH21]
474,00 MHz
%
100 %
Stopped
DVB-T Manual Tuning
Frequency
Signal Quality
Signal Strength
No.
Channel Name
Type
New
Free TV: 0
Pay TV: 0
Radio: 0
Data: 0
adjust frequency
select channel
t
Set where the level of [Signal Quality]
becomes the maximum.
Update DVB channel automatically [Update Channel List]
You can add new channels, delete removed channels, update channel name and position automatically to Channel List.
CH 5
69
Searching
DVB-T Update Channel List
Progress
This will take about 3 minutes.
CH
Channel Name
Type
Quality
Free TV: 0
Pay TV: 0
Radio: 0
t
Channel List is updated while keeping your settings in [Favourites Edit],
[Channel List], [Child Lock], etc.
t
Depending on the signal condition, the update may not work properly.
Display a notification message [New Channel Message]
Selects whether to give a notification message when a new DVB channel is found.
[Off] / [On]
New channels found!
Press OK to update channel list.
Press EXIT to ignore.
t
Selecting OK will perform [Update Channel List].
Check DVB signal [Signal Condition]
Selects a channel and checks the DVB signal condition.
A good Signal Strength is not an indication of suitable signal for DVB reception.
Please use the Signal Quality indicator as follows :
[Signal Quality] :
t
Green bar
Good
t
Yellow bar
Poor
t
Red bar
Bad (Check the Terrestrial aerial or cable)
Example :
t
To change the channel
70
CBBC
Channe
l
90
80
%
%
0.00E
+
00
Wenvoe
802,00
MHz,
64
QAM,
6940
kS/s
DVB-C Signal Condition
Signal Quality
Channel Name
Signal Strength
Bit Error Rate
Network Name
Parameter
These bars show the maximum signal value of the selected channel.
Reduce the DVB-C signal [Attenuator]
If the DVB-C signal is too strong, the interference may occur. In this case set to [On] to reduce the signal automatically.
t
This function is available only for DVB-C signal.
