Se
tup
Inserting/removing a disc
34
LSQT1021
∫
Identifying recording/playback sides of disc
Single sided disc:
The recording/playback side is opposite to the labelled side.
Double sided disc:
The “SIDE A” recording/playback side is opposite to the “SIDE A”
marked side. The “SIDE B” recording/playback side is the “SIDE A”
marked side.
DV
D-R
AM / SIDE
A
“SIDE A” mark
The opposite side is the
“SIDE A” recording/ playback
side.
≥
Do not use excessive force when opening the cover.
≥
Do not touch the pickup lens or the recording/
playback side of the disc.
This may impair recording and playback.
≥
Insert the disc securely to prevent damage.
≥
When you open the cover, the ACCESS/PC lamp
flashes red. Do not leave the cover open.
≥
If the cover is open, the power will not turn off even
if the OFF/ON switch is set to OFF.
≥
If the disc is not correctly inserted, the cover will not
close. Never try to forcibly close the cover. This
could cause damage. Reinsert the disc properly.
≥
If a single sided disc is inserted into the unit with the
printed label facing the inside, an error message will
appear. Remove the disc and reinsert it with its
recording/playback side facing the inside.
≥
Do not allow the recording/playback side to become
dirty or scratched.
≥
Do not remove the battery pack or disconnect the
AC adaptor while removing the disc or until power is
completely turned off. If you do, the cover will not
open. If this happens, reattach the battery pack or
reconnect the AC adaptor, slide the DISC EJECT
lever once, and then release it. A repair disc
message may be displayed when the power is
turned back on. (
l
147, About recovery)
≥
Do not insert anything other than the 8 cm DVD-
RAM, DVD-RW or DVD-R disc into the disc
compartment. Doing so could cause malfunctions.
≥
Do not touch the pickup lens or other parts inside
the disc compartment. Be sure not to touch the area
around the pickup lens for it becomes extremely
hot.
After inserting a disc/After recording finishes
While the ACCESS/PC lamp is lit, the disc is rotating and disc information is being recorded. If
the power supply is interrupted at this time, the disc may become unusable. Do not disconnect
the AC adaptor or remove the battery. Also, do not strongly shake or cause impact to the unit.
LSQT1021(ENG).book 34 ページ 2006年2月2日 木曜日 午後3時10分