35
Advanced Operation
Program End Search
Locates end point of recording for continuity.
Press SEARCH
twice in Playback or
Stop mode to display PROGRAM
END SEARCH screen .
1
SEARCH START
:
FF
EX I T
:
SEARCH
PROGRAM END SEARCH
Press FF
to start search.
Example of
Program End Search
operation.
Fig.1
Fig.2
Fig.3
If search exceeds a few seconds in BLANK area.
PLAYBACK DIRECTION
Program 1
Program 2 or BLANK
INDEX
Program 2
BLANK
INDEX
BLANK
Program 1
Program 2
BLANK
Program 1
INDEX
Press SEARCH button
Press SEARCH button
FF
FF
Press SEARCH button
FF
End Point
2
End Point
Upon locating end point...
The unit searches slightly past end point,
reverse searches, and plays the last few
seconds of the program, then stops.
Press SEARCH button
• If Program End Search is started very close
to an index mark, that mark may be
skipped over.
End Point
Note
*Important: If a remote control button does not work when pressed, press the
button on the remote
and try the button again.
To cancel,
press PLAY
or
STOP.
DF2702-K(P34-37 tape OP).p65
2002/03/08, 18:28
35
