Panasonic UF-E1, Руководство по обслуживанию

Страница: 94 / 271

UF-E1
90
544 XMT ECM D Stopped Transmission after EOR Trans-
mission. Line is faulty.
NCU PCB abnormal.
550 XMT B No response received within 45 sec
after sending training. Line quality is poor. Try it again.
552 RCV C No response received within 12 sec
after sending RNR. Ask transmitter to send again and
receive it into memory. (Use Memory
Reception)
554 XMT ECM D Transmitted ERR after receiving EOR. Faulty line.
555 XMT ECM D Transmitted PIN after receiving EOR. Faulty line and Operator Call requested
by RX side.
570 RCV B Password or machine code did not
match duringremotediagnosticcommuni-
cation.
571 XMT B Remote unit did not have the remote
diagnostic function.
572 XMT C There was no response while machine
transmitted the data during remote diag-
nostic communication. Remote unit is defective.
573 RCV C Unit could not receive the data from
remote unit duringremotediagnostic-
communication. Remote unit is defective.
623 XMT A No document was in the ADF. (Built-in
dialer engaged) Operator removed the document from
the ADF after dialing was completed.
Document is not set properly in the ADF.
630 XMT or
RCV
(Polling)
B Redial count over. No dial tone detected.
Second dial tone is not detected. (coun-
try dependent) Busy tone is detected.
(country dependent) T1 timer (35±5 sec)
elapsed without a signal from the
receiver.
631 XMT A “STOP” button was pressed during Auto
Dialing.
634 XMT Redial count over with no response.
638 XMT Power turned off with applicable data in
memory or during communication. Power switched off. Power failure
occurred.
712 Internet
XMT
Incorrect destination email address. Check the registered email address.
714 XMT
RCV Email communication error. Try to connect again.
716 Internet
XMT/RCV
Cannot logon to the designated DNS
Server, SMTP Server or POP Server. Incorrect DNS Server IP Address.
Incorrect SMTP or POP Server Name.
717 Internet
XMT/RCV
Incomplete SMTP Protocol transmis-
sion. Mail Server’s hard disk may be full.
Mail Server is defective.
720 Internet
XMT/RCV
Unable to connect with the POP Server. Incorrect POP Server Name is set.
POP Server is down.
721 Internet
XMT/RCV
Unable to login to the POP Server. Incorrect POP User Name or Password
is set.
725 Internet
XMT/RCV
DNS Server connection timed out. Incorrect DNS Server IP address is set.
DNS Server is down.
726 Internet
XMT/RCV
Received an error response from the
DNS Server. Check the DNS Server IP address.
Incorrect POP Server Name is set.
Incorrect SMTP Server Name is set.
Information Code
Code Mode Phase Description of Problem Cause