Panasonic UF 890 - Panafax B/W Laser, Руководство по обслуживанию

Страница: 22 / 94

22
540 XMT ECM B No response after transmitting 3rd
CTC or DCN received. Incompatible interface.
541 XMT ECM D No response after transmitting 3rd
EOR or received DCN. Line is faulty.
LCU PCB abnormal.
542 XMT ECM D No response to the 3rd RR trans-
mitted or received DCN. Remote unit is abnormal.
543 XMT ECM D T5 timer (60 sec.) elapsed without
MCF. Remote unit is abnormal.
544 XMT ECM D Stopped Transmission after EOR
Transmission. Line is faulty.
LCU PCB abnormal.
550 RCV ECM C Timer between frames in phase C
has elapsed. Defective remote station.
554 RCV ECM D Transmitted ERR after receiving
EOR. Faulty line.
555 RCV ECM D Transmitted PIN after receiving
EOR. Faulty line and Operator Call
requested by RX side.
570 RCV B Password or machine code did not
match during remote diagnostic
communication.
571 XMT B Remote unit did not have the
remote diagnostic function.
580 XMT B Sub-address transmission to a unit
that has their DIS bit 49 (NSF bit
155) OFF. Sub-address transmission to a
unit that has no Sub-address
function.
581 XMT B Sub-address Password transmis-
sion to a unit that has their DIS bit
50 (NSF bit 156) OFF. Sub-address transmission to a
unit that has no Sub-address
function.
601 XMT ADF Door was opened during ADF
transmission.
623 XMT A No document was in the ADF.
(Built-in dialer engaged) Operator removed the document
from the ADF after dialing was
completed.
Document is not set properly in
the ADF.
630 XMT or
RCV
(Polling)
B Redial count over. No dial tone detected.
Sensor dial tone is not detected.
(destination dependent)
Busy tone is detected.
(destination dependent)
T1 timer (35±5 sec.) elapsed
without a signal from the receiver.
631 XMT A "STOP" button was pressed during
Auto Dialing.
634 XMT B Redial count over with no response
or busy tone was not detected.
Note: U.S.A. / Canada models will
redial only once if busy tone is not
detected.
638 XMT Power turned off with applicable
data in memory or during
communication. Power switched off.
Power failure occurred.
Information Codes
Code Mode Phase Description of Problem Cause