11
Operating Instructions
Usage
Moving the Stand
Stowing the Projector Assembly
Prepare to move the stand by carrying out the steps below.
1
Disconnect the power cable from the power outlet.
2
Move the projector.
•
While lifting the projector arm slightly, turn it clockwise
or counterclockwise slowly, and move the arm so that
it is made parallel with the elite Panaboard unit.
Note
•
At the lowest point, the projector may come into
contact with the unit. Rotate the arm away, so
that the projector will not touch the unit.
3
Attach knob B (with the board bracket
attached) at the position shown in the figure
and secure the projector arm.
Note
•
The position of knob A varies depending on the
projector used.
4
Lower the elite Panaboard to the lowest point.
Note
•
If the height of the entrance is less than 2 m
(6 ft. 6
3
/
4
in.), proceed with steps 1 and 2, and after
having moved the projector, lower the height of the
projector arm by following the steps below.
1
Attach knob B to the top hole.
2
Lift the projector arm slightly and remove knob A
from the projector arm.
(The position of knob A varies depending on the
projector used.)
3
Lower the projector arm to the position where
knob B stops it.
4
Attach removed knob A to the securing position,
and secure the projector arm.
Knob B
Knob A
Hole for Securing
Projector Arm
Knob B
Knob A
UE-608030_EN.book 11 ページ ２０１０年１０月２８日 木曜日 午後４時２０分
