10
Operating Instructions
Usage
The pin end stoppers are provided at points along the
450 mm (1 ft. 5
23
/
32
in.) adjustment range. Use them at
points in the range from the highest point and at the
point where the elite Panaboard will be stopped by the
stoppers. When the system is to be moved, release
the safety brake (
1
) and simultaneously push one pin
end stopper (the one on the safety brake side) (
2
) and
lower the elite Panaboard slightly. Then
simultaneously push the other pin end stopper and
lower the elite Panaboard to the lowest point.
After
lowering the elite Panaboard to the lowest point, pull
the safety brake lever to secure the board.
Notice
•
When pushing the pin end stoppers and then moving
the elite Panaboard down to an even lower position,
remember that the projector will also be lowered at
the same time. Take care to prevent the projector from
hitting your head or other parts of your body.
•
Similarly, the up/down part on which the elite
Panaboard is installed will also move down to a low
position so exercise care when tall equipment has
been placed on the table plate.
•
Be careful to avoid pinching your finger in the pin end
stopper hole.
Using the elite Panaboard
1
Turn on the power of the computer and
projector.
2
When an image has appeared on the screen of
the elite Panaboard, adjust the projector. (Refer
to
“
Adjusting the Screen Image
”
(page 10).)
3
Turn on the power of the elite Panaboard.
4
Proceed with calibration.
(Refer to the Operating Instructions of the elite
Panaboard unit.)
Adjusting the Screen
Image
If the desktop screen image displayed has trapezoidal
distortion or if it is out of focus, adjust the projector,
and optimize the image.
Note
•
If projected images are distorted because the
projector lens has become deformed, it may not be
possible to align the position touched on the screen
with the display position even by performing
calibration.
Pin End Stopper
(Safety Brake Side)
Safety Brake
A
UE-608030_EN.book 10 ページ ２０１０年１０月２８日 木曜日 午後４時２０分
