Panasonic TX-40GX700E, Руководство по эксплуатации

Страница: 22 / 80

English
22
FAQs
Before requesting service or assistance, please follow
these simple guides to solve the problem.
For details, refer to [eHELP] (Support > FAQs).
The TV does not switch on
Check the mains lead is plugged into the TV and the
mains socket.
The TV goes into Standby mode
Auto power standby function is activated.
The remote control does not work or is intermittent
Are the batteries installed correctly? (p. 18)
Has the TV been switched on?
The batteries may be running low. Replace them with
new ones.
Point the remote control directly at the TV’s remote
control signal receiver (within about 7 m and a
30 degree angle of the signal receiver).
Situate the TV away from sunshine or other sources
of bright light so they do not shine on the TV’s remote
control signal receiver.
No image is displayed
Check the TV is turned on.
Check the mains lead is plugged into the TV and the
mains socket.
Check the correct input mode is selected.
Check the selection of [Composite] / [Component] in
[Input Selection] to match the signal being output by
the external equipment.
Is [Backlight], [Contrast], [Brightness] or [Colour] in
the Video Menu set to the minimum?
Check all required cables and connections are firmly
in place.
An unusual image is displayed
Turn the TV off with Mains power On / Off switch,
then turn it on again.
If the problem persists, initialise all settings.
[Shipping Condition] (Setup Menu)
The image or sound from external equipment are
unusual when the equipment is connected via HDMI
Set [HDMI 2.0 Setting] (Setup Menu) to [4K@60Hz
4:2:0]
(p. 14)
Parts of the TV become hot
Parts of the TV may become hot. These temperature
rises do not pose any problems in terms of
performance or quality.
When pushed with a finger, the display panel moves
slightly and makes a noise
There is a little gap around the panel to prevent
damage to the panel. This is not a malfunction.
Moving image is not smooth
Intelligent Frame Creation automatically compensates
the picture frame rate and removes juddering
movements to make the images smooth.
However, smoothness of moving image is not
guaranteed for certain input stream formats.
The LED indicator flashes red
Please reset the TV by unplugging it from the
electrical outlet if the LED flashes red.
After a minute, plug the TV back in to the electrical
outlet.
If the flashing continues, contact your TV dealer or
Panasonic service center.
About the inquiry
Please contact your local Panasonic dealer for
assistance.
If you make an inquiry from a place where this TV
is not present, we cannot answer about contents
that require visual confirmation for connection,
phenomenon, etc. of this TV itself.