REFERENCE
48
Programming the Remote
Control Using Access Codes
The Mode Selection Buttons control the operation of a TV,
Cable box (CBL), VCR, Receiver (RCVR), Laserdisc player (LD),
and auxiliary devices (AUX) such as a CD player, a Cassette
Player or, a DVD player. The remote mode buttons can be set
to control other manufacturer’s devices by the following
methods.
When the Code is Known
(Preferred Method)
Procedure for setting up remote using the numerical buttons:
•
Determine the brand of the device.
•
Identify code(s) associated with the brand (see following
pages for code listings). Record the applicable code for
each device.
•
Confirm the device is plugged in and operating properly.
1.
Press and hold both the MENU/SELECT and the POWER
buttons at the same time for at least five seconds (all mode
buttons will flash); then release both buttons.
2.
Press the Mode button that you want to program (DSS,
TV, CBL, RCVR, VCR1, VCR2, AUX, or LD). The selected
mode button will illuminate steadily; all others will go out.
3.
Enter the three-digit code for the brand of device (from
the code list on the pages that follow) by using the number
buttons on the remote control.
–
When a valid code has been entered, the key
illumination will blink twice and then go out.
4.
Press POWER to send a test signal. If the code is correct,
the device will respond correctly.
Note that some brands have multiple codes. Repeat the
procedure using each listed code until the device responds
correctly.
–
If you enter an incorrect code or incomplete entry after
thirty seconds, the settings will not change.
This remote may not operate all
models of the brands that are shown.
Use the codes shown in this manual,
or on the sheet packed with your
remote.
1
2
3
4
5
6
7
8
9
0
R-TUNE
TV/VIDEO
POWER
MUTE
V
CR
1
VCR 2
A UX
LD
RC
VR
CBL
TV
DS
S
CH
CH
VOL
VOL
MENU
SELECT
GUIDE
EXIT
1
5
9
Remote Code
3
1
2
