Panasonic Toughbook CF-48 Series, Руководство по эксплуатации

Страница: 25 / 36

25
T
ro
u
b
leshooting
11 After the reinstallation procedure completes, the follow-
ing message will appear on the display.
Windows2000 install wizard will start after reboot.
Restore process will execute more after Windows2000 install wizard.
Restart the computer after removing Product Recovery CD-ROM.
12 When the message [Press <F2> to enter SETUP] is dis-
played, press
F2 and then run the Setup Utility.
If the password has been set, enter the Supervisor Pass-
word.
13 Press F9 .
At the confirmation message, select [Yes] and press
Enter . (The Setup Utility settings will return to their
default values. Even the security settings with the excep-
tion of the password(s) will return to their default values.)
Change the settings where necessary.
14 Press F10 .
At the confirmation message, select [Yes] and press
Enter .
15 Perform the setup procedure for Windows by following
the instructions on the screen.
Windows 2000 page 11
Windows XP page 12
Windows 2000
10 At the confirmation message, press Y .
The operations of reinstallation for the hard disk start au-
tomatically. (The operations take about 15 minutes.)
When the message “insert the next CD” is displayed, in-
sert the Product Recovery CD-ROM showing the next
number in the sequence, and then select [OK].
(In the case of Windows 2000, only Product Recovery
CD-ROMs 1 to 3 can be used.)
If [OK] is not immediately selected:
The message “The media does not contain the correct
file” may appear. When [OK] is selected, the message
“insert the next CD” will be displayed again.
Confirm that the proper Product Recovery CD-ROM
has been inserted by opening the tray of the CD drive
and then close the tray, then immediately select [OK].
NOTE
Windows XP install wizard will start after reboot.
Restore process will execute more after Windows XP install wizard.
Restart the computer after removing Product Recovery CD-ROM.
Windows XP
Remove the Product Recovery CD-ROM, then restart the
computer by pressing
Ctrl + Alt + Del .