9-14
1. Insert the TS Flex into the TS Controller, and attach the tape.
2. Remove the Release Paper A and attach the TS Controller.
(Do not float the sheet and apply the load on the LCD.
3. Remove the Release Paper B and attach it on the TS Controller.
4. Remove the Release Paper C and attach it on the LCD.
<Notes>
1. Apply the load when attaching the attaching parts. 20 ~ 30N (2 ~ 3Kgf)/cm2
TS Controller Attach.
Release Paper B
Release Paper A
Release Paper C
Flex Stiffening
Plate Edge
0
䌾
2
Insert the TS Flex.
Tape Attach.
10
㫧䋱
㩷
㪇䌾㪈
㪈㪉㫧㪉
8
㫧
2
0
㫧
1
㪇㪂㪉
5
㫧
2
0
㫧
2
0
㫧
2
0
㫧
2
1. Apply the load when attaching the attaching parts. 20 to 30N (2 to
3Kgf)/cm2
2. Reusing the attaching parts is impossible.
Fix with Screws in order of the rear number of No.
Ex.) Fix in order of
Ԛ
-1 to
Ԛ
-2.
3
䇮
Torque of Screw
㽵
=0.45
㫧
0.05N
䊶
m(
㻍
4.50
㫧
0.5kgf
䊶
cm)
Put the side of the socket pin up
and insert it into the CN of LCD.
Insert
the CN.
Insert
the CN.
Insert
the CN.
Insert
the CN.
TOP CASE
SHEET-1Attach.
TOP CASE
SHEET-3Attach.
TOP CASE
SHEET-4Attach.
TOP CASE SHEET-2Attach.
CABLE TAPE-2Attach.
CABLE TAPE-1Attach.
Tape Attach.
Avoid catching the Cable in the Cabinet
Match to the slotted
hole edge.
㫧
2
Avoid catching the
Cable in the Cabinet
Care for tape floating
0
㫧
2
Process the wire to avoid
running over the INV shield case.
Match the end.
Along the bottom of Connector
Avoid catching.
Vertical Direction: Match to the edge
of INV MILL SHIELD
Lateral Direction: Match to the left edge
of Connector.
Tolerance:
r
2
Vertical Direction: Match to the heater edge.
Vertical Direction: Match to the damper
sheet edge.
Tolerance:
r
2
Process the Cable after bending it.
Avoid catching the Cable in the Cabinet
Insert the CN (blue).
Tighten
SCREW-1
Tighten
SCREW-2
Insert the CN (red).
INV-PWB
A'ssy Set
Avoid loosening when
processing the INV Cable.
(Avoid catching the Cable
in the Cabinet.)
Connect the LCD Cable.
LCD cable BUSH Set
Avoid catching the Cable in the Cabinet
Insert the rubber
groove into the
Cabinet rib firmly.
CAUTION
S1:Insulation S2:Bitten S3:Sharp Edge
S4:Part No. Check S5:Other
S2
S2
S2
S2
S2
S2
