Panasonic TH-58PX600U, Руководство по обслуживанию

Страница: 39 / 185

12 Adjustment
12.1. White balance adjustment
Instrument Name Connection Remarks
· W/B pattern
· Color analyzer
(Minolta CA-100 or equivalent)
Component input
Panel surface User setting: Normal
Procedure Remarks
·
Ensure aging is adequate.
· Make sure the front panel to be used on the final set is fitted.
·
Make sure a color signal is not being shown before adjustment.
· Put the color analyzer where there is little color variation.
1. Output a white balance pattern.
2. Check that the color temperature is “cool”.
3. Set to factory mode, WB-ADJ.
4. Set “R-CUT” “G-CUT” “B-CUT” the values written in table A.
5. Attach the sensor of color analyzer to the center of highlight window.
6. Fix G drive at C0h and adjust “B-DRV” and “R-DRV” so x, y value of color analyzer
become the “Color temperature High” in table 1.
7. Increase RGB together so the maximum drive value in RGB becomes FCh. That is, set
“ALL DRIVE” to FCh.
8. Set color temperature to “Normal”.
9. Set “R-CUT” “G-CUT” “B-CUT” the values written in table A.
10. Attach the sensor of color analyzer to the center of highlight window.
11. Fix G drive at C0h and adjust “B-DRV” and “R-DRV” so x, y value of color analyzer
become the “Color temperature Mid” in table 1.
12. Increase RGB together so the maximum drive value in RGB becomes FCh. That is, set
“ALL DRIVE” to FCh.
* When WB-ADJ(mid) is adjusted by data-offset, set values as follows.
R-DRV : the same as R-DRV_cool
G-DRV : “G-DRV_cool” -2hDAC
B-DRV : “B-DRV_cool” -22hDAC
13. Set color temperature to “Warm”.
14. Set “R-CUT” “G-CUT” “B-CUT” the values written in table A.
15. Attach the sensor of color analyzer to the center of highlight window.
16. Fix G drive at C0h and adjust “B-DRV” and “R-DRV so x, y value of color analyzer
become the “Color temperature Low” in table 1.
17. Increase RGB together so the maximum drive value in RGB becomes FCh. That is, set
“ALL DRIVE” to FCh.
* When WB-ADJ(warm) is adjusted by data-offset, set values as follows.
R-DRV : the same as R-DRV_cool
G-DRV : “G-DRV_cool” -AhDAC
B-DRV : “B-DRV_cool” -62hDAC
18. Set color temperature to “Cool”.
19. Copy values adjusted by HD pattern to the NTSC data area of EEPROM.
Pic Menu: Vivid
Picture: +30
ASPECT: FULL
· Highlight section
Signal amplitude 75%
39
TH-58PX600U