English
14
Watching TV
1
Turn power on
(TV)
or
(Remote Control)
●
Mains power On / Off switch should be on.
(p. 13)
Displays the information bar at the bottom of the screen
for several seconds.
●
For information about the operation and settings,
refer to [eHELP]. (Search by Purpose > Read first >
Features)
2
Select the mode
●
Selectable modes vary depending on the channels
stored.
3
Select a channel
up
down
or
●
To select a channel position with 2 or more-digit, e.g.
399
Tick the TV signal mode to tune, and then select
[Start Auto Tuning]
: tune (search for the available channels)
: skip tuning
Select your region (Satellite)
Auto Tuning is now complete and
your TV is ready for viewing.
If tuning has failed check the RF cable, and the network
connection, and then follow the on-screen instructions.
Note
●
The TV goes into Standby mode when no operation
is performed for 4 hours if [Auto Standby] in the Timer
Menu is set to [On].
●
The TV goes into Standby mode when no signal is
received and no operation is performed for
10 minutes if [No signal Power off] in the Timer Menu
is set to [On].
●
To retune all channels
[Auto Tuning] in [Tuning Menu] (Setup Menu)
●
If no satellite channel is found, set [LNB Band
Frequency] to suit your environment.
[LNB Configuration] in [Satellite TV Tuning
Menu] (Setup Menu)
●
To add the available TV signal mode later
[Add TV Signal] in [Tuning Menu] (Setup Menu)
●
To initialise all settings
[Shipping Condition] in [System Menu] (Setup
Menu)
TH-50FS500Z_Eng.indb 14
TH-50FS500Z_Eng.indb 14
3/12/2018 9:25:24 AM
3/12/2018 9:25:24 AM