English
62
Serial ID function
Set to control external control with the PC connected to
SERIAL terminal according to the Display’s ID number
(Panel ID).
[Off]:
Disables external control by the ID.
[On]:
Enables the external control by the ID.
LAN control protocol
Select the LAN control protocol.
[Protocol 1]:
Control with the Panasonic Display
sequence.
[Protocol 2]:
Control with the sequence that
compatible with Panasonic Projector.
Note
Ɣ
For PJLink and WEB browser control, the operation is
possible regardless of the setting.
Ɣ
When performing the command control with TCP/IP,
select [Protocol 1].
Ɣ
When operating the Early warning software or Multi
Monitoring & Control Software, select [Protocol 2].
Information timing
Set up the informing manner for no signal.
During RS-232C controls:
Warning or error message sent on the display
automatically.
During LAN controls:
Acquire the warning or error message from the
display.
1
Select the item with .
Select the set point with .
Information timing
No signal warning
No signal warning timing
No signal error
No signal error timing
On
5min
On
10min
[No signal warning]
When set to [On], the display sends out the no signal
warning.
[No signal warning timing]
Set up the detecting time for no signal warning.
(Range: 01 - 60, Interval: 1 minute)
[No signal error]
When set to [On], the display sends out the no signal
error.
[No signal error timing]
Set up the detecting time for no signal error.
(Range: 01 - 90, Interval: 1 minute)
Ɣ
The warning of [No signal warning] and the error of
[No signal error] are not sent when the no signal state
is detected through any of the following functions:
[No signal power off], [HDMI1 power management],
[HDMI2 power management], [DVI-D power
management], [PC power management] (see page
51)
Ɣ
If there is no signal when [PC IN] is input, [PC power
management] is activated first and the Display enters
the standby mode.
Setting Example:
[No signal warning timing]: 5 minutes
[No signal error timing]: 10 minutes
[PC power management]: [On] (60 seconds)
Note
Ɣ
The [No signal error timing] cannot be set shorter
than [No signal warning timing].
