23
Adjusting POS. /SIZE
H-Pos
Adjust the horizontal position.
V-Pos
Adjust the vertical position.
H-Size
Adjust the horizontal size.
V-Size
Adjust the vertical size.
Clock
Phase
(During Component, RGB and PC input signal)
Eliminate the ickering and distortion.
Dot Clock
(During Component, RGB and PC input signal)
Periodic striped pattern interference (noise) may occur when a striped pattern is displayed. If this happens,
adjust so that any such noise is minimized.
Over scan
Turn image over scan On/Off.
Con gurable signals are as follows:
525i, 525p, 625i, 625p, 750/60p, 750/50p (Component Video, DVI, HDMI)
On Off
Notes:
• “Off” is effective during only “16:9” aspect mode.
• When “Off” is set, “H-Size” and “V-Size” cannot be adjusted.
1:1 Pixel
Mode
Adjusts the display size when 1125i or 1125p signal is input.
Notes:
• “On” is effective during only “16:9” aspect mode.
• Select On when you would like to replay 1920 × 1080 input signal.
• Applicable input signal;
1125 (1080) / 50i · 60i · 24sF · 24p · 25p · 30p · 50p · 60p
• Select Off when ickering is shown around the image.
• H-Size and V-Size cannot be adjusted when On is selected.
Off
On
While the Pos. / Size display is active, if either the N button on the remote control is pressed at any time or the ACTION ( ) button is
pressed during “Normalise”, then all adjustment values (except “Clock Phase” and “Dot Clock”) are returned to the factory settings.
Helpful Hint ( /
Normalise
Normalisation)
