Panasonic Super Dynamic III WV-NS202A, Руководство по обслуживанию

Страница: 10 / 38

1-2
Rear view
•
MONITOR OUT
AUDIO OUT MIC IN
EXT I/O
4 3 2 1
DC12V IN
POWER
INITIAL
SET ACT LINK
10BASE-TX
100BASE-TX
Safety wire holder
Monitor out connector
Audio output connector
Microphone in connector
External I/O terminals
DC 12 V power terminals
Power LED
[INITIAL SET] button
Cable guide
Network connector
Link LED
Access LED
Screw hole for a tripod (1/4-20UNC)
About the [INITIAL SET] button
Turn on the power of the camera while holding down this button, and wait for around 5 seconds without releasing this button. Wait
another 1 minute after releasing the button. The camera will restart and the settings including the network settings will be initialized.
The settings including the network settings will be initialized. Note that the preset position settings will not be initialized.
Important:
Use this hole only when the camera is to be
installed on desktop using a tripod.
Do not use this hole to mount on the ceiling since
the fall prevention measure is unavailable.