Panasonic Super Dynamic III WV-CW484S, Руководство по эксплуатации

Страница: 36 / 96

36
AWC Setting
1. Select AWC and press the [LEFT] button.
→
AWC will change to AWC
→
PUSH SW.
2. Press the [SET] button.
→
PUSH SW will be highlighted while the AWC setting is performed.
Note: If the white balance is not set, PUSH SW is being highlighted.
3 . Press the [RIGHT] button.
Manual Fine Adjustment
Perform fine adjustment as necessary.
1. Select WHITE BAL and press the [SET] but-
ton.
→
Fine adjustment menu of ATW or AWC will
open.
2. Adjust finely R (Red) and B (Blue) gain by
moving the "I" cursor.
8. Motion Detection Setting (MOTION DET)
When a series of changes in pictures is detected, the camera outputs an alarm to the external
device such as a disk recorder. The recorder will start recording the pictures.
1. Select a mode for MOTION DET on the CAMERA SETUP menu.
The default setting is OFF.
OFF: Disables the alarm output.
MODE1: Outputs alarm when a series of
motions is detected.
MODE2: Outputs alarm when a series of
scene changes is detected.
→
The MODE1 menu opens when you select
MODE1 and press the [SET] button.
2. Adjust for LEVEL to optimize the sensitivity of
detection.
3. Select a dwell time. The default setting is 2S.
Available time (second): 2, 5, 10, 30
The next detection will be performed after
the set time elapses.
4. Select MASK SET and press the [SET] but-
ton.
→
A 48-split screen opens.
• Specify non-detection (mask) and detection areas in the same way as described earlier in
2-2 ALC Mode.
• Hold down the [SET] button for 2 seconds to return to the MODE1 menu.
Note: Perform the setting of mask area after STABILIZER in the CAMERA SETUP menu is
set to OFF.
**ATW1**
R ...I...128
- +
B ...I...128
- +
RET TOP END
** MODE1 **
LEVEL ...I..128
- +
DWELL TIME 2S
DISPLAY MODE
ALARM OFF
MASK SET
RET TOP END
↵
↵