576-10-770
DBS 576 - Issued 3/23/98
5
Introduction
The incorporation of a voice recognition unit (VB-44101) in a
soft
-key
telephone (VB-44224) allows you to choose between voice-activated dialing
or normal keying in. You can simply speak names stored in the Phonebook to
initiate a call to that destination.
This manual describes how to use voice-activated dialing and how to record
names, etc. See the Operation Instruction (Section 700) for details of normal
key operations.
This manual consists of the following chapters:
•
We recommend storing your spoken commands in your own voice in
the system to improve the performance of voice recognition.
Chapter
Content
Reference page
1. Making outside call
(or Internal call)
Describes how to make calls to exchange (or in-
ternal) numbers by speaking names recorded in
the Phonebook
8
2. Adding a Phonebook
Entry
Describes how to record names and phone num-
bers in the Phonebook
10
3. Modifying a Phone-
book Entry
Describes how to change names and phone num-
bers recorded in the Phonebook
14
4. Deleting a Phonebook
Entry
Describes how to delete names and phone num-
bers from the Phonebook
21
5. Tuning the commands
to Your Voice
Describes how you, as user, store your spoken
commands in the system for use as a reference.
26
6. Resetting The System
Describes how to reset the system to its state
when shipped (The original non-specific "user"
voice is restored and the contents of the Phone-
book deleted.)
30
CAUTION:
• If the system cannot recognize your spoken commands, operate by
keys. There is no key equipped on the telephone corresponding to
"Repeat" command.
• Your spoken command can be recognized only during Large LED
(Message LED) lights Red.
• When a spoken command is not recognized, an error tone is gener-
ated. At this point, make sure your spoken command is valid and
try again.
• Once entering the voice recognition made, to turn to the OFF-
HOOK Monitor mode is not available. To use OFF-HOOK Moni-
tor mode, lift the handset and press ON/OFF Key, then press
START Key.