![background image](http://html.mh-extra.com/html/panasonic/sc-ua7/sc-ua7_operating-instructions-manual_278417014.webp)
14
RQ
T0
B
24
14
Using a microphone
Preparation
Decrease the volume of the system to its minimum before
you connect or disconnect a microphone.
1
Connect a microphone (not supplied) to the
microphone jack.
Plug type: Ø 6.3 mm monaural
2
Press [MIC VOL/KARAOKE EFFECT] to select
“MIC1 VOL” or “MIC2 VOL”.
3
Press [
Y
,
U
] to adjust the volume of the
microphone.
If you want to sing with the background music.
4
Play the music source and adjust the volume of
the system.
Note:
•
If a strange noise (howling) is emitted, move the
microphone away from the speakers, or decrease the
volume of the microphone.
•
When you do not use the microphone, disconnect it from
the microphone jack, and decrease the volume of the
microphone to its minimum.
•
This system cannot record from microphone.
Clock and timers
Setting the clock
This is a 24-hour clock.
1
Press [SETUP] to select “CLOCK”.
2
Press [
Y
,
U
] to set the time and then press [OK].
To check the time
Press [SETUP] to select “CLOCK” and then press
[OK].
In standby mode, press [DISPLAY].
Note:
Reset the clock regularly to maintain accuracy.
Sleep timer
The sleep timer switches off the system after the set time.
Press [SLEEP] to select the setting (in minutes).
To cancel, select “OFF”.
To check the remaining time
Press [SLEEP].
Note:
•
The remaining time is shown for a few seconds every
minute. “SLEEP 1” is always shown when only 1 minute
remains.
•
The play timer and sleep timer or the record timer and sleep
timer can be used together.
•
The sleep timer always comes first. Be sure not to set an
overlap of timers.
Play timer and record timer
(Except for Bluetooth
®
, D-IN, AUX 1 and AUX 2
source)
You can set the timer to come on at a certain time to:
• Wake you up (play timer).
• Record from the radio (record timer).
Play timer and record timer cannot be used together.
Preparation
Set the clock.
1
Press [SETUP] to select “TIMER ADJ”.
2
Press [
Y
,
U
] to select “
#
PLAY” or “
#
REC” and
then press [OK].
3
Press [
Y
,
U
] to set the start time and then press
[OK].
4
Do step 3 again to set the end time.
5
For play timer, press [
Y
,
U
] to select the source
you want to play and then press [OK].
6
For record timer, press [
Y
,
U
] to select “MEMORY”
or “USB B” to keep the recording and then press
[OK].
To start the timer
1
Prepare the source.
2
Press [SETUP] to select “TIMER SET”.
3
Press [
Y
,
U
] to select the setting and then press
[OK].
“
#
” is shown.
The system must be switched off for the timer to
operate.
To check the setting
1
Press [SETUP] to select “TIMER ADJ”.
2
Press [
Y
,
U
] to select “
#
PLAY” or “
#
REC” and
then press [OK].
In standby mode, press [DISPLAY] two times.
Play timer
Prepare the source you want to
listen to (USB, internal memory or
radio) and set the volume.
Record timer
Connect the USB device to
USB B
(for USB recording) and tune in to
the radio station.
PLAY ON
Start the play timer.
PLAY OFF
Cancel the play timer.
REC ON
Start the record timer.
REC OFF
Cancel the record timer.
SC-UA7 E RQT0B24-1E.book Page 14 Tuesday, May 31, 2016 2:18 PM