11
TQ
BJ
20
15
11
█
Selecting a preset station
1
Press [PLAY MENU] repeatedly to select
“TUNE MODE”.
2
Press [
R
,
T
] to select “PRESET” and then press
[OK].
3
Press [
2
/
3
] or [
5
/
6
] to select the preset
station.
Using the unit
1
Press [
8
] to select “PRESET”.
2
Press [
2
/
3
] or [
5
/
6
] to select the preset
station.
Improving the sound quality
1
Press [PLAY MENU] repeatedly to select
“FM MODE”.
2
Press [
R
,
T
] to select “MONO” and then press
[OK].
To cancel, select “STEREO”.
“MONO” is also cancelled when you change the
frequency.
To memorise the setting
Continue with step 4 of “Manual presetting”.
(
Z
page 10)
Checking the signal status
Press [DISPLAY] to select “FM STATUS”.
RDS broadcasting
This system can show the text data transmitted by the
radio data system (RDS) available in some areas.
Press [DISPLAY] repeatedly.
Note:
RDS may not be available if reception is poor.
Clock and timers
Setting the clock
This is a 24-hour clock.
1
Press [SETUP] repeatedly to select “CLOCK”.
2
Press [
R
,
T
] to set the time and then press [OK].
To check the time
Press [SETUP] repeatedly to select “CLOCK” and
then press [OK].
In standby mode, press [DISPLAY].
Note:
Reset the clock regularly to maintain accuracy.
Play timer
(Except for Bluetooth
®
, AUX and D-IN source)
You can set the timer to come on at a certain time to
wake you up.
Preparation
Set the clock.
1
Press [SETUP] repeatedly to select “TIMER ADJ”.
2
Press [
R
,
T
] to set the start time and then press
[OK].
3
Do step 2 again to set the end time.
4
Press [
R
,
T
] to select the source you want to play
and then press [OK].
To start the timer
1
Prepare the source you want to listen to (disc,
USB or radio) and set the volume.
2
Press [SETUP] repeatedly to select “TIMER SET”.
3
Press [
R
,
T
] to select “PLAY ON” and then press
[OK].
“
#
” is shown.
To cancel, select “PLAY OFF”.
The system must be switched off for the timer to
operate.
To check the setting
Press [SETUP] repeatedly to select “TIMER ADJ” and
then press [OK].
In standby mode, press [DISPLAY] two times.
Note:
•
The timer starts at a low volume and increases gradually to
the preset level.
•
The timer comes on at the set time every day if the timer is
on.
•
If you switch off the system and then switch on again while
a timer is in operation, the timer will not stop at the end
time.
FM – – – –
The FM signal is weak.
The system is not tuned in to a station.
FM ST
The FM signal is in stereo.
FM MONO
“MONO” is selected as the “FM MODE”.
The FM signal is in monaural.
PS
Programme service
PTY
Programme type
FREQ
Frequency
ENGLISH
UA3.4E_TQBJ2015.book Page 11 Wednesday, June 7, 2017 3:28 PM
