12
VQT4E52
≥
For a safety measure to prevent the speakers from falling, refer to page 16.
≥
To prevent damage or scratches, lay down a soft cloth and perform the assembly on it.
Attach the front ornaments.
≥
Keep the screws out of reach of children to prevent swallowing.
≥
Be sure to insert the screws following the order as indicated in the illustration.
Connect the speaker cables.
≥
Insert the wire fully, taking care not to insert beyond the wire insulation.
≥
To make sure that the speaker cable is connected to the correct speaker, match the colour of the speaker connector with
the colour of the L/R indicator on the speaker label so as not to connect the speaker cable to the wrong speaker.
Drive a screw (not supplied) into the wall.
≥
Use the measurements indicated below to identify the screwing positions on the wall.
≥
Leave at least 20 mm of space above and each side of the speaker to allow enough space for fitting the speaker.
≥
The position in the wall where the screw is to be attached as well as the screw should be capable of supporting over
33 k
g
.
≥
Keep the screws out of reach of children to prevent swallowing.
Place the speakers vertically
∏
1 Speaker (L)
∏
1 Speaker (R)
∏
2 Speaker cables
(L): WHITE
(R): RED
∏
4 Screws
∏
2 Front
ornaments
1
Insert the wire fully while
pushing the lever.
r
: White
s
: Blue line
2
Press into the groove.
2
1
Front view
Rear view
Push
SC-HTB20EBEGGNGS_VQT4E52.book 12 ページ ２０１２年２月２４日 金曜日 午後７時５１分
