Getting started
11
VQT4E52
Connect the speaker cables.
≥
To make sure that the speaker cable is connected to the correct speaker, match the colour of the speaker connector with
the colour of the L/R indicator on the speaker label so as not to connect the speaker cable to the wrong speaker.
≥
Insert the wire fully, taking care not to insert beyond the wire insulation.
Drive a screw (not supplied) into the wall.
≥
Use the measurements indicated below to identify the screwing positions on the wall.
≥
Leave at least 20 mm of space above and each side of the speaker to allow enough space for fitting the speaker.
≥
The position in the wall where the screw is to be attached as well as the screw should be capable of supporting over
33 k
g
.
≥
Keep the screws out of reach of children to prevent swallowing.
Fit the speaker securely onto the screw(s) with the hole(s).
1
Insert the wire
fully while
pushing the lever.
r
: White
s
: Blue line
2
Press into the
groove.
A
At least 30 mm
B
‰
4.0 mm
C
‰
7.0 mm to
‰
9.4 mm
D
Wall or pillar
E
5.5 mm to 6.5 mm
Front view (semi-transparent image)
F
190.5 mm
G
187 mm
H
177 mm
I
200.5 mm
J
12.5 mm
K
Wall mounting hole
DO
DO NOT
≥
Move the speaker so
that the screw is in
this position.
≥
In this position, the
speaker will likely fall
if moved to the left or
right.
Push
SC-HTB20EBEGGNGS_VQT4E52.book 11 ページ ２０１２年２月２４日 金曜日 午後７時５１分
