R
Q
T
8766
6
Simple
Se
tu
p
Preparation
≥
To prevent damage or scratches, lay down a soft cloth and perform assembly on it.
≥
For assembly, use a Phillips-head screwdriver.
≥
Make sure you have all the indicated components before starting assembly, setup, and connection.
≥
There is no difference between the right and left speakers and stands.
≥
For optional wall mount, refer to page 8.
[HT995]
[Note]
≥
The front and surround speakers are different.
– Check the label on the rear of speaker before attaching the stand (
➜
page 9).
– The stand with shorter cable is for the front speaker.
1
Attach the speaker to the stand.
Place the polyfoam underneath the speaker for stability while
attaching the speaker to the stand.
1
Feed the speaker cable (the shorter part) into the bottom
of the speaker and through the slot at the rear.
2
While pulling the speaker cable up through the slot, slide
the speaker stand into the bottom of the speaker.
3
Thread the cable through the middle hole of the slider and
fasten the slider with the two screws.
2
Attach the stand to the base.
1
Thread the speaker cable through the base.
For quicker threading, loosely fold the cable in half (do not
crease), pass the folded portion through the hole, and then pull
the rest of the cable through the base.
2
Insert the stand into the base while gently pulling on the
end of the cable.
3
Secure the stand to the base.
4
Adjust the speaker height.
1
Loosen the screws until
the speaker can slide up
and down the stand.
2
Raise the speaker to the
desired height, and then
re-tighten the screws.
5
Connect the speaker cable.
6
Secure the speaker cable to the base.
STEP
1
Assembling the front and
surround speakers
The supplied stands are specially designed for
attachment to Panasonic SB-FS995 front
speakers, SB-FS996 surround speakers or
SB-FS990 front speakers, SB-FS540 surround
speakers. Use only as indicated in this setup.
2 Front speakers and
2 Surround speakers
4 Bases
4 Stands
≥
2
k
stands with short cable:
For front speakers
≥
2
k
stands with long cable:
For surround speakers
12 Screws
4 Sliders
Cable
Speaker
Stand
Polyfoam
Screws
Tighten securely.
Slider
Cable
Base
Rounded side
Large hole
Cable
Cable
Screw
Tighten securely.
Phillips-head
screwdriver
_
: White
`
:
Blue
Insert the wire fully.
Push!
Press the speaker cable into the groove.
Push excess cable back through the
slider holder.
Cable
Slide the cable
into the groove.
As
sem
b
ling
the
fr
ont
and
surr
ound
spe
ake
rs
The speaker height
can be adjusted.
Min
: 110 cm
Max
: 135 cm
HT995 & HT995W.book Page 6 Thursday, April 27, 2006 8:17 PM
