Panasonic SC-BT100, Руководство по эксплуатации

Страница: 18 / 52

18
QT9129
Enjoying the FM/AM radio
Manual tuning
Press [FM/AM] to select “FM” or “AM”.
Main unit: Press [SELECTOR].
Press [ , ] to select the frequency.
Main unit: Press [
"
] or [
#
].
When a radio broadcast is being received, “TUNED” lights in the
display.
When a stereo broadcast is being received, “ST” lights in the
display.
To start automatic tuning, press and hold [ , ] until the frequency
starts scrolling. Tuning stops when a station is found.
Presetting stations manually
Up to 30 stations can be set in each band, FM and AM.
Press [FM/AM] to select “FM” or “AM”.
Press [ , ] to select the frequency.
Press [OK].
“P” and “M” begin to flash.
Press the numbered buttons to enter
preset channel number.
To select a 1-digit number
e.g., “1”: [1]
>
[OK].
To select a 2-digit number
e.g., “12”: [1]
>
[2].
A station previously stored is overwritten when another station is stored in the same
channel preset.
Repeat steps to to set other stations.
Selecting the preset channels
Press [FM/AM] to select “FM” or “AM”.
Press the numbered buttons to select the channel.
To select a 1-digit number
e.g., “1”: [1]
>
[OK].
To select a 2-digit number
e.g., “12”: [1]
>
[2].
Alternatively, press [ , ] or [ , ] to select the
channel.
If noise is excessive
When “FM” is selected
Press [FM MODE] to display “MONO”.
Press the button again to cancel the mode.
The mode is also canceled when you change the frequency.
This setting can be preset for each broadcasting station. When
“MONO” appears follow procedures
and in “Presetting stations manually”
(
>
above).
When “AM” is selected
Press [AM BP] to select “AM BP1” or “AM BP2” that receives good reception.
Each time you press the button:
AM BP1
AM BP2 (BP=Beat Proof)
FM frequency step
Main unit only
The step is factory-set to 0.2-MHz (200-kHz), but you can change it to receive
broadcasts allocated in 0.1-MHz (100-kHz) steps.
Press [SELECTOR] to select “FM”.
Press and hold [SELECTOR].
After a few seconds the display changes to show the current minimum frequency.
Continue to hold the button down. The minimum frequency changes and the step is
changed.
To return to the original step, repeat steps
and .
After changing the setting, previously preset frequencies will be cleared. Preset them
again.
[OK]
[
, ]
[FM MODE]
[AM BP]
[ , ]
[ , ]
Numbered
buttons
[FM/AM]
[SELECTOR] [
"
], [
#
]
TUNED
ST TUNED
M
e.g., “12”
e.g., “12”
NOTE
MONO TUNED
TUNED
e.g., “AM BP1” is selected.