10
SQT1211
1 Disconnect the AC mains lead.
2 Connect this unit to a broadband
router, etc. using a LAN cable.
3 Connect the AC mains lead to this
unit, and turn the unit on.
≥
When the connection is established, the network
indicator (blue) lights up.
≥
Use category 5 or above straight LAN cables (STP)
when connecting to peripheral devices.
≥
The LAN cable must be connected or disconnected while
the AC mains lead is disconnected.
≥
Inserting any cable other than a LAN cable in the LAN
port can damage the unit.
≥
If the LAN cable is disconnected, the network-related
settings (
l
right) will be initialized. In that case, make the
settings again.
≥
When a LAN cable is connected, the Wi-Fi function will
be disabled.
– Power consumption will be reduced when the unit is
turned on or is in standby mode.
You can change this unit’s name on the network,
and use specific IP address, subnet mask,
default gateway, primary DNS, etc.
Preparation
≥
Complete the network settings. (
l
7)
1 Connect your device to the same
network as this unit.
2 Check this unit’s IP address (
l
19),
and note it down.
3 Start an Internet browser on your
device and then type this unit’s IP
address into the address field to
display the settings page.
≥
It may take a few minutes until the settings page is
displayed depending on the environment. In that
case, reload the browser.
≥
If the unit is connected with Wi-Fi, only a device
name can be changed. Close the settings page after
changing the device name.
– To change the device name, select “Change”,
and type a new device name, and then select
“Apply”.
4 Type a device name and then select
“Next”.
≥
Refer to the step 4 of “Using an Internet browser”
(
l
8) for details on a device name.
5 Select and input the details.
≥
If your network requires specific settings, deselect
“DHCP” to disable DHCP.
– You can use specific IP address, subnet mask,
default gateway, primary DNS, etc.
6 Select “Connect” to apply the
settings.
≥
When the connection is established, the network
indicator (blue) lights up.
Using a LAN cable
[SC-ALL9]
[SC-ALL6]
Broadband router, etc.
e.g.,
LAN cable
(not supplied)
To make network-related
settings
You can also change the name of this unit by changing
a setting in the app “Panasonic Music Streaming”
(version 2.0.8 or later) (
l
11). For details on the app,
refer to the site below.
http://panasonic.jp/support/global/cs/audio/app/
(This site is in English only.)
SC-ALL9&6-SQT1211_mst.book 10 ページ 2016年1月12日 火曜日 午後3時16分