SQT1211
9
∫
Network standby
This unit will turn on automatically from standby
mode when you select the unit as the output
speakers.
≥
Network standby is normally active while the unit is
connected to a network.
≥
The power consumption in standby mode will increase
when the network standby is active. To reduce the power
consumption in standby mode, turn off the network
standby.
Touch and hold [NET] and [AUX] for at least
4 seconds.
The mode indicator blinks once.
On
The mode indicator blinks twice.
Off
≥
To keep the network standby turned off, select
Bluetooth
®
, AUX or rear surround (
[SC-ALL6]
) as the
audio source before switching the unit to standby mode.
≥
If this function is set to on, the network (wired LAN/Wi-Fi)
remains active even in standby mode.
– The power consumption in standby mode will
increase.
≥
If this function is set to off, the network (wired LAN/Wi-Fi)
is disabled in standby mode.
– The network (wired LAN/Wi-Fi) will be enabled when
the unit is turned on.
– The power consumption in standby mode will be
reduced.
≥
If the network indicator is blinking in blue and red, wait
until the blinking stops.
≥
When the unit is turned on by this feature, the beginning
part of the music may not be played back.
≥
Depending on the app, the conditions for activating this
function may differ.
≥
The unit may not turn on even when selected as the
output speakers. In that case, start playback.
∫
Network reset
Touch and hold [NET] and [1] for at least
4 seconds.
≥
The network indicator starts blinking blue/red.
≥
This function is disabled when this system is
connected with a LAN cable.
≥
Do not connect a LAN cable. Doing so will
disable the Wi-Fi function.
1 Turn this unit on.
≥
Proceed to the next step after the network indicator
changes from blinking in blue and red to blinking
slowly in blue.
2 Touch and hold [NET] on the unit for
at least 4 seconds.
≥
The network indicator (blue) blinks.
3 Activate the WPS button on the
wireless router.
≥
When the connection is established, the network
indicator (blue) lights up.
∫
Using the WPS PIN code
After step 1
2 Touch and hold [NET], [1] and [2] for
at least 4 seconds.
≥
The network indicator (blue) blinks faster.
3 Enter the PIN code “64428147” into
the wireless router.
≥
When the connection is established, the network
indicator (blue) lights up.
≥
Once the unit enters WPS PIN code mode, you cannot
set up using the WPS button. To use the WPS button,
turn off and then on the unit, and redo the network
settings.
≥
Depending on a router, other connected devices may
temporarily lose their connection.
≥
For details, refer to the operating instructions of the
wireless router.
Using WPS (Wi-Fi Protected
Setup
TM
)
A compatible wireless router may have the
WPS identifier mark.
e.g.,
SC-ALL9&6-SQT1211_mst.book 9 ページ ２０１６年１月１２日 火曜日 午後３時１６分
