2
2. Cautions
●
This product is not equipped with a short-circuit protection circuit. Use a power supply having a
short-circuit protection function (e.g. fuse, etc.).
●
Verify that the supply voltage variation is within the rating. Also, check the voltage variation at the end terminal of the
transmission route, since voltage drop occurs depending on the diameter or the length of the transmission cable.
●
If power is supplied from a commercial switching regulator, ensure that the frame ground (F.G.)
terminal of the power supply is connected to an actual ground.
●
Do not use during the initial transient time after the power supply is switched ON. Furthermore, transmission
is not possible when the system is in Busy state (during switching ON of the power supply or system setting.)
●
Make sure to use an isolation transformer for the DC power supply. If an auto-transformer (sin-
gle winding transformer) is used, this product or the power supply may get damaged.
●
In case a surge is generated in the power supply used, connect a surge absorber to the supply
and absorb the surge.
● In case computer power supply is turned OFF first, note that the output hold function of the
S-LINK V
output units may not work.
Power supply
●
Do not run the wires together with high-voltage lines or power lines or put them in the same
raceway. This can cause malfunction due to induction.
●
Make sure to carry out the installation and wiring in the power supply OFF condition.
●
In order to reduce noise, make the wiring as short as possible.
● Always use the specified transmission cable.
●
Take care that wrong wiring will damage the product.
Wiring
●
This product has been developed / produced for industrial use only.
●
In case noise generating equipment (switching regulator, inverter motor, etc.) is used in the vicin-
ity of this product, connect the frame ground (F.G.) terminal of the equipment to an actual ground.
●
This product does not have a dust-proof or water-proof construction. Do not use it in a place
having excessive vapor, dust, etc.
●
Take care that the product does not come in contact with water, chemicals or organic solvents,
such as thinner, etc. Furthermore, do not use it in an environment having corrosive gas.
● Do not use the product in places where the ambient temperature or the humidity exceeds the specifications.
Environment
● Do not tighten the screws with a torque exceeding the specifications.
Terminal
●
S-LINK V
system is not compatible with
system.
●
Please refer to “
S-LINK V User's Manual
” for details of the system design.
●
Any protective devices or safety circuits against system malfunction should be designed to be
external to the system.
Others
1. Introduction
Thank you very much for purchasing Panasonic products. Please read this Instruction Manual
carefully and thoroughly for the correct and optimum use of this product. Kindly keep this manual
in a convenient place for quick reference.
●
Never use this product in a device for personnel protection.
●
In case of using devices for personnel protection, use products which meet laws and standards, such
as OSHA, ANSI or IEC etc., for personnel protection applicable in each region or country.
●
Before touching this product, remove any electrostatic charge that may be present on your body.
There is a danger of this product getting damaged due to the electrostatic charge.
