Panasonic PV-DAC10, Руководство по обслуживанию

Страница: 10 / 195

1-8
HOW TO REMOVE A JAMMED TAPE
Electrical Method
CAUTION:
If loading does not start after DC Power Supply is applied,
DO NOT continue to applying DC Power Supply. In this
case, perform in Manual Method.
Remove a jammed tape as follows:
(1) Remove the Cabinet Parts. Refer to "CABINET SECTION"
in DISASSEMBLY/ASSEMBLY PROCEDURES.
(2) Apply +3 V DC Power Supply to the Loading Motor terminals.
(3) When the Loading Posts reach the fully unloaded position,
remove the Power Supply immediately.
Note:
DO NOT let eject the Garage Unit. If the Garage Unit is in
the up position, the DV Cassette Tape may be damaged.
Fig. 6-1
(4) Rewind the tape into the DV Cassette Tape by turning the
Capstan Rotor clockwise.
Fig. 6-2
(5) Eject the DV Cassette Tape by ap3 VDC Power
Supply again.
(6) Take out the DV Cassette Tape from the Garage Unit.
Manual Method
(1) Remove the Cabinet Parts. Refer to "CABINET SECTION"
in DISASSEMBLY/ASSEMBLY PROCEDURES.
(2) Remove the Head Amp C.B.A. from Mechanism. Refer to
"MECHANISM SECTION" in DISASSEMBLY/ASSEMBLY
PROCEDURES.
(3) Move the Pinch Roller Unit out so that the Pinch Roller is
separated from the Capstan Rotor Unit shaft. Then, remove
the tape from the tape path and all posts.
Fig. 6-3
(4) Rewind the tape into the DV Cassette Tape by turning the
Capstan Rotor clockwise.
(5) Eject the DV Cassette Tape by sliding the Lock Lever.
Fig. 6-4
(6) Take out the DV Cassette Tape from the Garage Unit.
Capstan Rotor
Capstan Rotor Unit shaft
Top View
Pinch Roller
Tape
Move
Side View
Lock Lever
Slide
Eject Eject
DC Power Supply
(+3 VDC)
"a"
"b"
Loading
Motor
Loading
Posts