- 3 -
Indoor Plastic Camera Mount - PUM8
General Instructions:
Note
: Mounting hardware for bracket is not supplied.
1. Carefully remove all equipment from the box.
2. If camera bracket is to be mounted on a wall: (
Note
: Bracket
is shipped assembled for wall mounting applications.)
A. Place the bracket against a flat surface in the desired
location. Mark the location using the three mounting holes.
B. Remove the bracket and drill a cable access hole
approximately in the center of the three marked mounting
holes.
C. Next, run the cable from the wall through the cable
access hole on the bracket body (See Fig. 1). Using the (3)
three marks from the previous step, mount the bracket to
the wall using appropriate fasteners.
D. Be sure the bracket is firmly affixed to the surface and
replace the (3) three hole covers (See Fig. 2).
E. Using the 1/4-20 screw (I) on the tilt mount (D) attach a
camera with a maximum camera length of (8) eight
inches (Fig. 3). Complete all electrical connections with
the camera.
F. Adjust the pan/tilt capabilities of the bracket with the (2)
two knobs, one for panning (H) and one for tilting (F) (Fig.
4). Tighten both knobs when desired viewing angle is
achieved.
3. If Camera Bracket is to be ceiling mounted:
H. Follow steps A-C. Once the cable access hole is drilled in
the ceiling, loosen the panning knob so the pan mount (E)
and tilt mount are released from the front cover (C) (Fig. 5).
I. Take front cover off the bracket body (Fig. 6). Replace the
front as shown (Fig. 7). Reattach the pan mount and tilt
mount to the front cover by tightening the panning knob.
J. Follow steps D-G.
Hole covers
F Tilt knob
H Pan knob
C Front cover
I 1/4-20 Screws
D Tilt mount
C Front cover
Fig. 1
Fig. 2
Fig. 3
Fig. 4
Fig. 5
Fig. 6
Fig. 7
J Security tool
B Hole covers
A PUM8
E Pan mount
C Front cover
!
Maximum weight for camera/lens: 3 lbs.
