- 14 -
Service Manual
5.
Wire the anode lead wire.
Figure 17. Wire Guide.
6.
Install yoke with other CRT neck assemblies on
CRT neck in the same order and position as
removed from the defective CRT.
7.
Press yoke against bell of CRT and tighten the
clamp just snug enough so it will not easily shift.
8.
Assemble CRT focus lens assembly to new CRT
with (4) screws. Make sure focus lens adjustment
nut is in the same location as on other CRT focus
lens.
Figure 18. CRT Screw Tightening Order.
Note: Please assemble with screws in the order
shown and tighten with the same torque.
Optical Block Position Adjustment
Figure 19. Optical Block Position.
The optical block mounting has holes to allow for the
different size projection screens. These mounts will
adjust to 61 inch & 51 inch projection screens.
If the optical block is removed for service or is
replaced, it is important that the correct mounting holes
are used.
Optical Bracket (Front)
RED CRT
GREEN CRT
BLUE CRT
1
2
3
4
51/61
51/61
51/61
51/61
51/61
51/61
46
46
46
46
46
46
Содержание PT51HX41E - 51" PROJECTION TV
