Panasonic PT-VW535N, Руководство по эксплуатации, Страница: 42 / 152

*1 The indicator will light as the following order:
2.75 seconds (light) → 0.25 seconds (off)
*2 The indicator will light as the following order:
2.0 seconds (light) → 2.0 seconds (off)
*3 The indicator will light as the following order:
0.5 seconds (light) → 0.5 seconds (off)
Note
f
If the power indicator <ON(G)/STANDBY(R)> is blinking in red in a cycle of 2.75 seconds (light) → 0.25 seconds (off) → 0.75
seconds (light) → 0.25 seconds (off) → 0.75 seconds (light) → 0.25 seconds (off), please consult your dealer.
Powering On the Projector
Before switching on the projector, make sure all the other devices are correctly connected (
Æ
page 36) and remove the lens
cap.
3) 3)
1)
2)
1) Connect the power cord to the projector body.
2) Connect the power plug to an outlet.
f
The power indicator <ON(G)/STANDBY(R)> lights or blinks, and the projector will enter the standby mode.
3) Press the power button <
v
/
b
> on the control panel or on the remote control.
f
The power indicator <ON(G)/STANDBY(R)> lights in green and the image is soon projected on the screen.
Attention
f
Be sure to remove the lens cap before starting projection.
Note
f
If the [PROJECTOR SETUP] menu → [ECO MANAGEMENT] → [STANDBY MODE] is set to [ECO] (
Æ
page 81) , it may
take approx. 10 seconds longer before the projector starts projecting after the power is turned on, compared with when
[NORMAL] is set.
f
If the [PROJECTOR SETUP] menu → [ECO MANAGEMENT] → [STANDBY MODE] is set to [NORMAL], it may take
approx. 1 minute to enable the network function after connecting the power cord.
When the initial setting screen is displayed
When the projector is switched on for the first time after purchase as well as when [INITIALIZE ALL] in the [PROJECTOR
SETUP] menu is executed, the focus adjustment screen is displayed after projection starts, then the initial setting screen is
displayed. Set them in accordance with circumstances.
In other occasions, you can change the settings by menu operations.
Initial setting (display language)
Select the language to show on the screen.
After completed the initial setting, you can change the display language from the [LANGUAGE] menu.
1) Press
asqw
to select the display language.
42 - ENGLISH
Chapter 3 Basic Operations - Powering on/off the projector