Panasonic PT-TW350D, Инструкция по эксплуатации (Функциональное руководство)

Страница: 34 / 108

34 - ENGLISH
Projecting
Check the connections of the peripheral devices ( Æ page 27) and connection of the power cord (
x
page 31) and switch
on the power (
x
page 32) to start the projector. Select the image and adjust the state of the image.
Selecting the input signal
Select an input signal.
1) Press the <INPUT/ENTER> button on the control panel or the input selection (<COMPUTER 1>, <COMPUTER 2>,
<HDMI>, <VIDEO> or <MEMORY VIEWER/USB DISPLAY/NETWORK>) buttons on the remote control.
f
The image of the signal being input in the selected terminal is projected.
Attention
f
Images may not be projected properly depending on the connected device and DVD, video tape, etc. to be played. Select a
system format that is suitable for the input signal in [Display] menu → [System] (
x
page 48).
f
Check the aspect ratio of the screen and the image and select the optimum aspect ratio under the [Display] menu →
[Aspect] (
x
page 47).
How to adjust the state of the image
When setting up the projector for the first time or setting up at a new place, you must perform the following operations.
1) Adjust the projection angle.
f
Install the projector on a flat surface and parallel to the screen so that the projected screen is rectangular.
f
If the screen is tilted downward, extend the adjustable feet and adjust the projection screen so that the projected screen
is rectangular.
f
For details, see “Adjusting adjustable feet” (
x
page 26).
2) Adjust the focus.
f
Rotate the focus ring to adjust the focus of the projected image.
Focus ring
Note
f
It is recommended that the images are projected continuously for at least 30 minutes before the focus is adjusted.
f
If you adjust the focus, you may need to adjust the size of the image by changing the distance between the screen and the
projector.
f
If keystone distortion occurs, see the [Expand] menu → [Keystone] (
x
page 58).
Chapter 3 - Basic Operations - Projecting