Panasonic PT-RZ120BEJ, Руководство по эксплуатации

Страница: 132 / 217

Chapter 4 Settings — [PROJECTOR SETUP] menu
132 - ENGLISH
12) Adjust [LIGHT OUTPUT] of each projector.
f
Adjust [LIGHT OUTPUT] of all the other projectors so that the brightness will be the same as the projector
with the least brightness.
13) Set [CONSTANT MODE] of [BRIGHTNESS CONTROL SETUP] to [AUTO], and [LINK] to [GROUP A] in
all projectors.
14) Select [APPLY] of [BRIGHTNESS CONTROL SETUP] and press the <ENTER> button in all projectors.
f
Brightness control starts.
Note
f
Brightness is automatically corrected whenever the light source lights up by switching on/off the projector, etc.
f
When the variation in brightness has increased due to aging of the light source, or when you replaced the light source, readjust the
brightness control.
[STANDBY MODE]
Set the power consumption during standby.
1) Press
as
to select [STANDBY MODE].
2) Press
qw
to switch the item.
f
The items will switch each time you press the button.
[NORMAL] Select this item when using the network function during standby.
[ECO] Select this item to reduce power consumption during standby.
Note
f
When [ECO] is set, the network function, the <SERIAL/MULTI PROJECTOR SYNC OUT> terminal, and some RS-232C commands become
inoperable during standby. When [NORMAL] is set, the network function and the <SERIAL/MULTI PROJECTOR SYNC OUT> terminal can
be used during standby.
f
When [ECO] is set, it may take approximately 10 seconds longer before the projector starts projecting after the power is turned on,
compared with when [NORMAL] is set.
f
The [STANDBY MODE] setting does not return to factory default setting even if the [PROJECTOR SETUP] menu → [INITIALIZE] → [ALL
USER DATA] is executed.
[QUICK STARTUP]
Set if the [QUICK STARTUP] function is enabled or disabled.
1) Press
as
to select [QUICK STARTUP].
2) Press
qw
to switch the item.
f
The items will switch each time you press the button.
[OFF] Disables the [QUICK STARTUP] function.
[ON]
Enables the [QUICK STARTUP] function until the specified time set in [VALID PERIOD] elapses after
the projector enters the standby mode. The time until the projection starts after the power is turned on
will be reduced during the period when the [QUICK STARTUP] function is valid.
f
Proceed to Step 3) when [ON] is selected.
3) Press the <ENTER> button.
f
The [QUICK STARTUP] screen is displayed.
4) Press
qw
to switch [VALID PERIOD].
f
The items will switch each time you press the button.
[30MIN.]
Sets the time until the [QUICK STARTUP] function is disabled after the projector enters the standby
mode.
Select a desired valid period.
[60MIN.]
[90MIN.]
Note
f
[QUICK STARTUP] cannot be set when [STANDBY MODE] is set to [ECO].
f
When [QUICK STARTUP] is set to [ON], the power consumption during standby becomes high during the period when the [QUICK
STARTUP] function is valid.