Panasonic PT-LB355U, Руководство по эксплуатации, Страница: 93 / 115

ENGLISH - 93
Power/Warning Indicators
If a problem should occur inside the projector, the power indicator <ON(G)/STANDBY(R)> and the warning indicator
<WARNING> will inform you by lighting or blinking. Check the status of the indicators and remedy the indicated problems as
follows.
Attention
f
Before you take a remedial measure, follow the procedure of switching the power off indicated in “Powering Off the
Projector” (
x
page 37).
Power indicator <ON(G)/STANDBY(R)>
Warning indicator <WARNING>
Power indica-
tor <ON(G)/
STANDBY(R)>
Warning
indicator
<WARNING>
Status Cause Solution
Off Off
The power plug is not
connected to the outlet.
--
Connect the power plug to
an outlet.
Red
Blinking Lighting in red It has reached the replace-
ment time of the lamp unit.
f
The indicator lights up
when the usage time of
the lamp unit reaches
20 000 hours (when
[Lamp control] is set to
[ (Eco)]).
f
Replace the lamp unit.
Blinking Blinking in red
It has exceeded the replace -
ment time of the lamp unit
and the projector is turned off
automatically.
f
The indicator blinks when
the usage time of the
lamp unit reaches
22 000 hours (when
[Lamp control] is set to
[ (Eco)]).
Green
Lighting Lighting in red
The replacement time of the
lamp unit is displayed. (Pro -
jecting)
f
Is the lamp replacement
warning icon
displayed when turn on
or turn off the projector?
f
The indicator lights up
when the usage time of
the lamp unit reaches
20 000 hours (when
[Lamp control] is set to
[ (Eco)]).
f
Replace the lamp unit.
Lighting Blinking in red
It has exceeded the replace -
ment time of the lamp unit
and the projector is turned off
automatically.
f
The indicator blinks when
the usage time of the
lamp unit reaches
22 000 hours (when
[Lamp control] is set to
[ (Eco)]).
Blinking Off
The power cord is plugged
and the lamp is turned off.
(Ready state)
f
[Power management] is set to [Ready].
If a video signal is input in Ready mode, or when you
press any button other than the power
<
v
/
b
> button, the luminous lamp turns on and the
projector enters the projection state. Pressing the
power <
v
/
b
> button during the Ready state will enter
the standby state. (
x
page 69)
Chapter 6 Maintenance - Power/Warning Indicators