Panasonic PT-LB305, Руководство по эксплуатации, Страница: 71 / 119

ENGLISH - 71
3) Press
as
to select [Capture].
f
Display the image you want to project at projector start-up.
4) Press the <ENTER> button.
5)
A confirmation screen is displayed, press
as
to select [Yes] and then press the <ENTER> button.
f
The captured image is registered as a user logo on this projector.
f
After capturing the image, the [Logo select] is set to [User]. The user logo will be displayed when the projector starts up
next time.
Note
f
Only supports still image-based computer (RGB) and still image-based HDMI signals input.
f
Capture may not be available depending on the input signal.
f
It is recommended to capture the same resolution signal as the display dots (panel resolution) of the projector.
For PT-LW375, PT-LW335 : 1 280 x 800
For PT-LB425, PT-LB385, PT-LB355 and PT-LB305 : 1 024 x 768
f
[Capture] cannot be set if [Logo PIN code lock] is set to [On].
f
The correction state of the [Keystone] will be canceled temporarily when the image is being captured.
[Logo PIN code lock]
Prevent the logo from being changed by any person other than the administrator by setting a three-digit Logo PIN code.
1) Press
as
to select [Logo].
2) Press the <ENTER> button.
f
The [Logo] screen is displayed.
3) Press
as
to select [Logo PIN code lock].
4) Press the <ENTER> button.
f
The
[Logo PIN code]
input screen is displayed.
5) Press the <ENTER> button.
6) Enter the Logo PIN code you have set according to the steps in "Enter a Logo PIN code".
f
To set the logo PIN code for the first time, you can enter the number (a three-digit number) you want to set according to
the steps in “Enter a Logo PIN code”.
r
Enter a Logo PIN code
i) Press
as
to select a number from 0 to 9.
ii) Press the <ENTER> button.
f
The fixed number change to

, the cursor move to the next digit.
iii) Repeat the above steps, and enter a three-digit number.
f
Move the cursor to [Set] after fixing the three-digit number.
iv) Press the <ENTER> button.
f
Return to the [Logo] screen.
7) Press
as
to switch the item.
f
The items will switch each time you press the button.
[On] Select this item to disable setting or changing of [Logo select] and [Capture].
[Off] Select this item to enable setting or changing of [Logo select] and [Capture]
Attention
f
The initial Logo PIN code is "111".
f
Change the Logo PIN code periodically that is hard to guess.
Note
f
If you want to correct the digit, press the <MENU> button to reset the digit and then re-enter it.
f
Press the <ENTER> button after moving the cursor to [Cancel] to return the menu screen.
f
If you entered an incorrect digit, the digit (

) will turn red and reset, and then re-enter a digit.
Chapter 4 Settings - [Expand] menu