Panasonic PT-DS100XE ( ), Руководство по эксплуатации

Страница: 84 / 130

PROJECTOR SETUP menu
84
- ENGLISH
Settings
When the D7700 Series is selected
Q
Press ▲▼ to select input signal 1.
[DVI-D] or [SDI].
[RGB1], [RGB2], [VIDEO], [S-VIDEO] and
z
[HDMI] cannot be selected.
Since [RGB1], [RGB2], [VIDEO], and [S-VIDEO]
are already installed on the projector, another
input signal change command cannot be
assigned.
[SDI] is not shown for PT-DW90XE.
z
Press ◄► to select the input signal 2.
change command to be assigned to
the selected input signal.
The signal change command can be selected
z
to either [AUX] or [NONE].
The same input signal change command
z
cannot be assigned to both [DVI-D] and [SDI].
STATUS
Displays the status of the projector.
Press ▲▼ to select [STATUS]. 1 )
Press <ENTER> button. 2 )
Press ◄► to move to the next page. 3 )
INPUT
Displays the input selection
state.
SIGNAL NAME Displays the input signal name.
SIGNAL
FREQUENCY
Displays the frequency of the
input signal.
PROJECTOR
RUNTIME
Displays the projector runtime.
LAMP1
*1
Displays the lighting time of
LAMP1.
LAMP2 *1
Displays the lighting time of
LAMP2.
INTAKE
AIR TEMP.
Displays the intake air
temperature of the projector.
OPTICS
MODULE TEMP.
Displays the temperature inside
the projector.
AROUND
LAMP TEMP.
Displays the temperature around
the lamp of the projector.
REMAINING
FILTER
QUANTITY
*2
Displays the filter remaining
quantity.
PROJECTOR
TYPE
Displays type of projector.
SERIAL
NUMBER
Displays the serial number of the
projector.
LAMP UNIT
MODEL NO.
Displays the component number
of the lamp unit.
LAMP1 SERIAL
NUMBER
Displays the serial number for
lamp1.
LAMP2 SERIAL
NUMBER
Displays the serial number for
lamp2.
MAIN VERSION
Displays the main version of the
firmware of the projector unit.
SUB VERSION
Displays the sub version of the
firmware of the projector unit.
NETWORK
VERSION
Displays the network version of
the projector unit.
EMULATE Displays the set emulate mode.
ON COUNT
POWER ON TIMES :
z
Displays the number of times
the power has been turned
on.
LAMP1 ON :
z
Displays the number of times
LAMP1 has been lit.
LAMP2 ON :
z
Displays the number of times
LAMP2 has been lit.
LAMP1
Displays the lighting time of
LAMP1. (HIGH or LOW)
LAMP2
Displays the lighting time of
LAMP2. (HIGH or LOW)
NUMBER OF
ENTRY SIGNAL
Displays the number of
registered signals.
REMOTE2
STATUS
Displays [REMOTE 2 IN] control
status.
AC VOLTAGE Displays the AC voltage state.
*1 :
Lamp replacement time =
LAMP POWER [HIGH] lighting time +
(LAMP POWER [LOW] lighting time x 3 ÷ 4)
REMAINING FILTER QUANTITY *2 :
If the remaining quantity of ACF becomes 8%,
the status display turns yellow. If the remaining
quantity becomes 0%, the display turns red.
If the residual filter indication becomes yellow,
the remaining usable time is about 200 hours.
The time of 200 hours is for reference only. It
depends on the usage environment.