42
Registering input signal data
Because the projector has no factory pre-set data of input signals, be sure to register input signal data before
first use.
• Up to 64 different input signals can be registered.
• Input a signal according to an input module installed on the projector and register the signal data.
Registration new signal
• If a new signal is input and MENU key of the remote control unit or projector operating panel buttons are pressed,
the new signal registration screen shown below will be displayed.
The registration procedure is given below.
Registration procedure
Press the MENU button. ... The NEW SIGNAL INPUT screen will be displayed.
Press the ENTER button. ... The SIGNAL STATUS screen will be displayed.
• Parameters such as the memory number, signal selector input number, slot input
number, type of input signal, frequency, and synchronizing signal are identified
and displayed automatically.
• The memory numbers are from A1 to H8.(Each from A to H has eight memory
numbers each.)
The lowest number of available memory numbers is displayed automatically.
If there is no available memory number, follow the overwriting procedure on the
next page.
• For the registration name (NAME), the signal name and memory number are
displayed automatically.
When using the original name displayed automatically on the screen without
change, press the ENTER button.
• The registration is complete and the display will return to the MENU screen.
When changing the original name, press LEFT(
) and RIGHT (
) arrow buttons
to select a letter or number and then press the UP (
) and DOWN (
) arrow
buttons to enter the selected letter or number. (To delete automatically displayed
names, press the STD (standard) button.)
After changing the name, press the ENTER button.
• The registration of the new name is complete and the display will return to the
MENU screen.
• If the MENU button is pressed instead of the ENTER button, the original
name will be registered instead of the new name.
NEW
SIGNAL
INPUT
ENTER
NEW
SIGNAL?
YES : ENTER
NO : MENU
SIGNAL
STATUS
NAME：SXGA89−A4
MEMORY-No.
：A4
S.S.No.
：1−2
INPUT No,
：1
fH
：47.50 kHz
fV
：89.00 Hz
SYNC
STATE ：H (POS)
V (POS)
75 ohm
POSITION :
SELECT :
SET : ENTER
CLEAR : STD
EXIT : MENU
NOTE
(Displayed contents is an
example)
NOTE
NOTE
