Panasonic ProLine AG-1340P, Руководство по обслуживанию

Страница: 42 / 84

STEP 2. “NAVI” DATA BACK-UP
PROCEDURE F.I.P. DISPLAY
Turn on the Service Mode.
1. Press FF and EJECT keys
simultaneously for more than
3 seconds.
Turn on the Service Mode 2.
2. Press FF and EJECT keys in twice.
Turn on the Set-up mode.
3. Press the EJECT key for more than
3 seconds.
Turn on the mode 6.
4. Press the CH UP key in 3 times.
Activate the Back-up.
5. Press the FF key for more than 3
seconds.
(OK)
“UP” is displayed when the Back-up
process has been done
successfully.
(NG) “31” is displayed when the Back-up
process has not been done
successfully.
(“31” is displayed mainly when the connection failure and ROM
failure of VFK1493P occurred. Confirm them and try again.)
STEP 3. REPLACE THE IC6001 AND/OR B6001
1. Disconnect the AC plug and replace the IC6001 and/or
B6001. (Do not make a short circuit between IC6001-pin 37
and other pins/components.)
CAUTION:
*When replacing the B6001, be sure to read/follow the
“HOW TO REPLACE THE LITHUM BATTERY” section.
STEP 4. RESET THE IC6001 AT ONCE
1. Connect the AC plug.
2. Connect a jumper wire between TL7510 and TW6090
(GND) for a second to reset the Microprocessor IC6001.
Note:
Since the resistance at pin 1 as well as pin 2 of IC6001
decides the model distinction data, no need to set up the
Model code, which is necessary in previous model.
STEP 5. LINE INPUT SETTING
1. Connect the 1.5 V battery to TL6010 or Pin 6 of IC6001 until
the FIP displays unreadable irregular characters.
2. Disconnect the AC plug for few seconds and connect it
again.
3. Confirm that “A1” and “A2” can be displayed on the FIP by
pressing the CH UP and CH DOWN buttons.
Note:
1. To set-up the “Plug in Auto Tuner Preset”, press the
Channel up and down keys simultaneously for 3
seconds.
2. Change the OSD setting to the Factory shipping
condition if necessary, by referring following charts.
STEP 6. NAVI. DATA WRITING/SAVING
1. Connect the Prog. Navi. Data Back-up Tool (VFK1493P)
PROCEDURE F.I.P. DISPLAY
Turn on the Service Mode.
1. Press FF and EJECT keys
simultaneously for more than
3 seconds.
Turn on the Service Mode 2.
2. Press FF and EJECT keys in twice.
Turn on the Back-up mode.
3. Press the EJECT key in more than
3 seconds.
Turn on the Back-up mode 6.
4. Press the CH UP key for 3 times.
Activate the NAVI. Data Writing.
5. Press the REW key in more than 3
seconds.
(OK) “dn” is displayed when the Back-up
process has been done
successfully.
(NG) “32” is displayed when the Back-up
process has not been done
successfully.
(“32” is displayed mainly when the connection failure and ROM
failure of VFK1493P occured. Confirm them and try again.)
Reset the Service Mode.
Normal Indication
6. Press FF and EJECT keys
simultaneously in 6 times.
NOTE: Perform the PG SHIFTER ADJUSTMENT.
6
AG-1340P